User manual PANASONIC SRW06PD

[. . . ] Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. Only connect the appliance to an earthed wall socket. Always make sure that the plug is inserted firmly into the wall socket. Do not use the appliance if the plug, the mains cord or the appliance itself is damaged. [. . . ] For the best results, do this just after the rice cooker has switched to keep-warm mode. The rice cooker has a backup memory that retains the last selected mode, function and settings in case of a power failure. The cooking process or the timer function will resume within 2 hours after the power supply is restored. Always press the KEEP-WARM/OFF button once before unplugging the rice cooker, as otherwise the last selected mode, function and settings will resume when the rice cooker is plugged in again. When the cooking process is finished, you will hear a beep. The cook/reheat light goes out and the keep-warm light starts to burn continuously to indicate that the rice cooker has automatically switched to the keep-warm mode. Do not exceed the maximum water level indicated inside the inner pot on the scale for congee cooking. You can set any time between 30 minutes and 4 hours. When the cooking process is finished, you will hear a beep. The cook/reheat light goes out and the keep-warm light starts to burn continuously to indicate that the rice cooker has automatically switched to the keep-warm mode. Cake recipe Ingredients: ready-made cake mix 250g; butter 65g; water or milk 100ml; 1 large egg. After 12 hours, the display will switch to the current time. After 12 hours, the keep-warm mode will end and the cook/reheat light will blink. Press the TIMER button to set the time when you want the food to be ready to eat. You can set a time from 0 minute up to 23 hours. 26) The cook/reheat light blinks and timer light burns continuously. When the cooking process starts, the cook/reheat light starts to burn continuously and the timer light goes out. You can put the time forward quickly by holding down the HR or MIN button. The time cannot be adjusted during the cooking or keep-warm process. Cleaning Unplug the rice cooker before starting to clean it. waituntilthericecookerhascooleddownsufficientlybeforecleaningit. To protect the non-stick coating of the inner pot, do not: - use the inner pot for washing dishes; - put vinegar into the pot. [. . . ] Water spills out of Too much water was used for cooking rice. LCD shows E1, E2, Electronic parts E3, E4 malfunction LCD shows E5 The display is off when the rice cooker is unplugged. Make sure that you add water to the level indicated on the scale inside the inner pot that corresponds to the number of cups of rice used. Make sure the water does not exceed the next level on the scale as this may cause overflow during cooking. [. . . ]