User manual PANASONIC SU-C1000

[. . . ] Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. Read Instructions ­ All the safety and operating instructions should be read before the product is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. heed Warnings ­ All warnings on the product and in the operating instructions should be adhered to. [. . . ] Safety Check ­ Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. Wall or Ceiling Mounting ­ This product should be mounted to a wall or ceiling only as recommended by the manufacturer. Heat ­ This product should be situated away from heat sources such as radiators, heat registers, stoves, or other products that produce heat. Do not place a flaming object, such as a candle or lantern, or near the product. Power Lines ­ An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. Outdoor Antenna Grounding ­ If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Item 7 is not required except for grounded or polarized equipment. Caution : Read the pages marked carefully to ensure safe operation. Unpack the unit carefully and make sure that all the accessories are present. Do not place any objects impairing heat radiation onto the top of the unit. Leave some space around the unit (from the largest outside dimension including projection) equal to or greater than, shown below. top panel : 50 cm Back panel : 10 cm ÷ Do not place the equipment onto a bed, a sofa, a carpet, or similar. Simply setting the POWER switch to OFF does not shut down the power supplied to the unit completely. To isolate this unit completely from the power supply, it is necessary to unplug the power cord from the power outlet. To shut down the power supply to the unit immediately in case of an emergency, connect the power plug to an easily accessible power outlet. Power plug To AC wall outlet Insert the power plug all the way and securely into a power outlet. AUDIO input is provided with high input gain so that it can accept the input from the headphones output of a portable component such as a HDD (Hard Disc Drive) audio player. If the line output from a desktop component such as a CD player is connected to these connectors, the audio is played at a larger volume than when it is connected to the CD or AUX connectors. In this case, however, the audio may be distorted if the listening volume is set too high. If their connections are imperfect, the sound may not be produced or noise may interfere. [. . . ] Incorrect installation may cause the unit to turn over or topple down and cause injuries. Always use the provided stands when installing the unit vertically. When installing the unit vertically, position it so that the POWER switch comes at the lower position as shown in the illustration. POWER switch When installing the unit, be careful not to block the ventilation openings to ensure sufficient heat radiation. [. . . ]