User manual PANASONIC SU-VZ220

[. . . ] Refer to the operating instructions supplied with the receiver and the other side of this guide. the illustrations in the guide designate speakers as through . Front left speaker Front right speaker Center speaker Surround left speaker Surround right speaker Surround back left speaker* Surround back right speaker* Sub woofer You can select the front speaker system. [. . . ] This is an example of how to connect this receiver and your components. Refer to step 4 of "Getting Started" of the operating instructions supplied with this receiver for details on other connections and other components. This receiver is equipped with function for converting video signals. * The surround back speakers (left/right) are compliant with the zone 2 operation. Connect the supplied AC power cord (mains lead) to the AC IN terminal on the receiver, then connect the AC power cord (mains lead) to a wall outlet. Connect the speakers according to the number and kind of your speakers. Use speaker cords, which are appropriate for the width of the room. By deciding on the color or mark of the speaker cord to be connected to the plus (+) or minus (­) connector, you can always be sure of connecting the cord correctly without mistaking plus or minus. You can set up the speakers to obtain the desired sound from all connected speakers automatically by using the auto calibration function. The size of a speaker (LARGE/SMALL) is determined by the low characteristics. However, you can change those settings in the Speaker settings menu. Save the measurement results first, then try to change the settings if you want. You should set up each component so that take out sound is output from speakers correctly when you play back a connected component. The auto calibration function allows you to measure the following: speaker connections, polarity of speakers, speaker distance, speaker angle, speaker size, speaker level, frequency characteristics. Sound may come out from only the front speaker left/right when 2 channel is selected. La fonction de calibrage automatique vous permet de déterminer ce qui suit : la connexion, la polarité, la distance, l'angle, la taille, le niveau des enceintes, les caractéristiques de la fréquence. Press / repeatedly and to un-check the items you do not want to measure. " 11 The measurement starts in five seconds. [. . . ] Press / repeatedly and to un-check the items you do not want to measure. " 11 The measurement starts in five seconds. The measurement process will take approximately 30 seconds with a test tone. [. . . ]