User manual PANASONIC SV-AV30U

[. . . ] R SD Multi AV Device Operating Instructions Model No. SV-AV30U Before use, please read these instructions completely. For USA assistance. please call:1-800-211-PANA(7262) or send e-mail to:consumerproducts@panasonic. com For Canadian assistance. please call:1-800-561-5505 or visit us at www. panasonic. ca VQT0C31-1 Before opening the CD-ROM package, please read the following. End User License Agreement You ("Licensee") are granted a license for the Software defined in this End User License Agreement ("Agreement") on condition that you agree to the terms and conditions of this Agreement. [. . . ] If the SD Multi AV Device is affected by magnetically charged equipment and does not function properly, turn off the SD Multi AV Device and detach the Battery or AC Adaptor and then connect the Battery or AC Adaptor again. Thereafter, turn on the SD Multi AV Device. Do not use your SD Multi AV Device near radio transmitters or high-voltage lines. If you record pictures near radio transmitters or high-voltage lines, recorded images or sounds may be adversely affected. Do not use the SD Multi AV Device for surveillance purposes or other business use. If you use the SD Multi AV Device for a long period of time, the internal temperature increases and, consequently, this may cause malfunction. The SD Multi AV Device is not intended for business use. When you use your SD Multi AV Device on a beach or similar place, do not let sand or fine dust get into the SD Multi AV Device. Sand or dust may damage the SD Multi AV Device. (Extra care should be taken when inserting and removing the Memory Card. ) Do not spray insecticides or volatile chemicals onto the SD Multi AV Device. If the SD Multi AV Device is sprayed with such chemicals, its body may be deformed and the surface finish may peel off. Do not keep rubber or plastic products in contact with the SD Multi AV Device for a long period of time. Do not use benzine, thinner or alcohol for cleaning the SD Multi AV Device. The camera body may be deformed and the surface finish may peel off. Before cleaning, detach the Battery or pull out the AC Main Lead from the AC Main socket. Wipe the SD Multi AV Device with a soft dry cloth. To remove stubborn stains, wipe with a cloth that is soaked in detergent diluted with water, and afterward, finish wiping with a dry cloth. 52 After use, be sure to take the Memory Card out and detach the Battery from the SD Multi AV Device or pull out the AC Main Lead from AC Main socket. If the Battery is used in an extremely cold environment, the Battery may only operate for approx. If the Battery becomes extremely hot, a protective function may operate, and the Battery may become unusable for a while. Remove the battery if the device is left unused for a long time. The temperature of the SD Multi AV Device and the battery may rise while charging the battery. Such rise of temperature does not indicate a fault. Do not install, remove, plug or unplug the battery or power cord while the power is on. ª About the LCD Monitor In a place with drastic temperature changes, condensation may form on the LCD Monitor. If your SD Multi AV Device is extremely cold when you turn its power on, the image on the LCD Monitor will be slightly darker than usual at first. [. . . ] The decision to repair or replace will be made by the warrantor. Product or Part Name SD Multi AV Device, SD Mobile Printer (except items listed below) CMOS Camera Assembly Rechargeable Battery Pack, SD Memory Card, AC Adaptor USB Reader-Writer (in exchange for defective item) Parts One (1) year Six (6) months Ninety (90) days Labor Ninety (90) days Ninety (90) days Not Applicable During the "Labor" warranty period there will be no charge for labor. During the "Parts" warranty period, there will be no charge for parts. You must carry-in or mail-in your product during the warranty period. If non-rechargeable batteries are included, they are not warranted. [. . . ]