User manual PANASONIC SV-AV100P

[. . . ] SD Video Camera Operating Instructions Model No. SV-AV100 Before use, please read these instructions completely. For USA assistance. please call:1-800-211-PANA(7262) or send e-mail to:consumerproducts@panasonic. com For Canadian assistance. please call:1-800-561-5505 or visit us at www. panasonic. ca PP VQT0F57 Before opening the CD-ROM package, please read the following. b=r=i=^ You ("Licensee") are granted a license for the Software defined in this End User License Agreement ("Agreement") on condition that you agree to the terms and conditions of this Agreement. [. . . ] Use the MediaStage for AV100 for operating files in the Memory Card. (l 85) [DCIM]: [MISC]: [SD_VIDEO]: The images (IMGA0001. JPG etc. ) in this folder are recorded in the JPEG format. ([100-0001] or similar indication is displayed on the SD Video Camera. ) Files in which DPOF Data has been set to the image are in this folder. Slide show data created by MediaStage for AV100 are in this folder. (AUTPLAY0. MRK etc. ) MPEG2 motion images (MOV001. MOD etc. ) and MPEG4 motion image is recorded in ASF format (MOL001. ASF etc. ). For other notes, see page 86. SR l `~==J=~= =~~==~= ~ This built-in battery is used for the memory of date and time. If [0] indicator is displayed when the power is on, the built-in battery may be exhausted. Charge using the following procedure: N N O Take the battery out and plug in the AC adaptor. (l 12) Turn the power off and leave the SD Video Camera as it is for approx. 12 hours. O The built-in battery can be used for about 6 months by 1 charge. (It changes with operating. ) After recharging the built-in battery, adjust the date and time. (l 22) r==l~= b~ While recording or playing back on an SD Video Camera, the sound can be heard using optional earphones. 1 ] 1 Plug the Earphone terminal in to the [ Terminal. If the volume while playing back is loud or soft, you can adjust the volume by using the Volume Adjustment Lever on the SD Video Camera, or the Volume Adjustment Button on the Remote Controller. (Adjustment of volume cannot be performed while recording. ) (l 31) If you use earphones be sure they have a length of cord less than 3 meters. SS r=^ Inserting the Button-type Battery Before using the Remote Controller, insert the supplied button-type battery. N 1 N O P While pressing the Stopper 1, pull out the Battery Holder. Insert the button-type battery with the imprint (r) facing upward. Insert the Battery Holder into the Remote Controller. When the button-type battery becomes weak, replace it with a new CR2025 battery. (A battery is normally expected to last about one year, however, it depends on operation frequency. ) Be sure to match the poles properly when inserting the battery. OIP Warning Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer's instructions. Do not recharge, disassemble, heat above 212xF (100xC) or incinerate. Keep the Button-Type battery out of the reach of children. If swallowed call your doctor. Replace battery with Panasonic PART NO. Use of another battery may present a risk of fire or explosion. Caution: Battery may explode if mistreated. [. . . ] Presionar para introducir los terminales de la batera en los terminales del compartimento de la misma y colocar la batera. Acoplar la batera con la etiqueta mirando hacia arriba. Despus de haber colocado la batera, cerrar la tapa. Carga de la batera O 1 N 2 3 Conectar el cable de entrada CC [DC IN 4. 9V] a la toma en la Videocmara SD. La luz indicadora de encendido 1 parpadea y la carga empieza. Durante la recarga, apagar la Videocmara SD. 4 5 Conectar el cable principal CA al adaptador CA y la toma principal CA. Esperar hasta que la luz indicadora de encendido 1 se apaga. Cuando la recarga ha terminado, la luz indicadora de encendido se apaga. 1 3 4 VR `=~~=~=ŷ~~== = Si se encaja la cmara en el soporte AV la carga es ms sencilla. [. . . ]