User manual PANASONIC SX-1800B

[. . . ] Do not place vases or other containers of liquids on the piano. Please read the safety instructions on page 6 on Operating Instructions. Warning! The piano top cover is quite heavy, and when opening it, be sure to insert the support into the hole to secure the top cover in the open position. Be careful when closing the top cover not to catch fingers or clothing under the top cover or in the hinges. [. . . ] Children should be advised not to open or close the top cover, and should not be permitted to operate the piano without adult supervision. The following mark and symbols are located on bottom of the unit. CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. 4 Following the assembly, connect the respective cords. (Piano bottom side) PEDAL IN mark AC IN Plug Pedal cord Power cord · Use the included clamps to secure the cords. Place the insulators (included) under the casters, positioning the Technics Piano in the desired location. Use the adjusters to make the pedal unit secure. Caution If the Technics Piano is to be moved, be sure to first shorten the adjusters in order to prevent pedal unit damage and scratching the floor. Confirm After assembling, check these points. Are any parts left over? Does the piano rattle when it is rocked? Is the power cord firmly inserted? Check again. Insulator Adjuster Check the assembly procedure again. Make sure all the screws are securely tightened. Is the plug of the pedal cord inserted as far into the connector terminal as it will go? If it is not completely inserted, the sustain and other pedal functions may not work. Does the pedal box move when the pedals are pressed? Turn the adjuster to stabilize the pedal box. When the piano has been moved or transported, retighten the screws securely. 2 Operations The Sostenuto (CENTER) pedal is added. About the Sostenuto pedal, refer to page 121 on the Operating Instructions. Step 2 of the PEDAL SETTING is different from the PR54. (page 121 on the Operating Instructions. ) 2. [. . . ] (page 121 on the Operating Instructions. ) 2. Use the L and M buttons to select pedal, and the and buttons to select its function. There is no USB terminal. (page 134 on the Operating Instructions. ) CD-ROM is not included. [. . . ]