User manual PANASONIC SX-5000R

[. . . ] DEUTSCH 38 ~ 49 Bevor Sie das Gert in Betrieb nehmen, lesen Sie bitte diese Bedienungsanleitung aufmerksam durch und bewahren Sie sie fr die knftige Verwendung auf. ITALIANO 50 ~ 61 Prima di utilizzare l?unit, leggere a fondo queste istruzioni per l?uso e conservarle come riferimento futuro. NEDERLANDS 62 ~ 73 Lees deze gebruiksinstructies goed door voor u het apparaat gebruikt en bewaar ze voor toekomstig gebruik. PORTUGUS 74 ~ 85 Antes de utilizar o aparelho, leia completamente este manual de instrues e guarde-o para futuras referncias. [. . . ] Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. This displays , and the airflow automatically swings up and down. Cooling and drying The flap (vertical airflow flap) can be set to one of three positions. Heating Set the flap (vertical airflow flap) to the downward position. If the flap is set to the upward position, the warm air may not reach the floor. Fan operation All operations Initial setting Initial setting Initial setting Continuous operation To stop the swing operation Press the FLAP button again during the flap swing operation to stop the flap at the desired position. Then, the airflow can be set from the top position by pressing the FLAP button again. Indicator when swing operation is stopped Fan and heating Cooling and drying During cooling or drying operation, the flap will not stop at the downward position. Even if the flap is stopped at the downward position during the swing operation, it will not stop until it moves to the third position from the top. 8 01_85464609176012_EN. fm Page 9 Wednesday, October 3, 2012 1:49 PM ADJUSTING AIRFLOW DIRECTION (CONTINUED) Y1 type air conditioner is equipped with auto flaps. You can set the airflow direction to a specific angle or to the sweep mode using the remote controller. ? One outdoor unit and eight indoor units No display Unit No. 1?3 10 01_85464609176012_EN. fm Page 11 Wednesday, October 3, 2012 1:49 PM SPECIAL REMARKS ??DRY??Once the room temperature reaches the level that was set, the unit repeats the cycle of turning on and off automatically. In order to prevent the humidity in the room from rising again, the indoor fan also turns off when the unit stops operating. operation is not possible if the outdoor temperature is 15 C or less. Heating Operation Heating performance ?Because this appliance heats a room by utilizing the heat of the outside air (heat pump system), the heating efficiency will fall off when the outdoor temperature is very low. If sufficient heat cannot be obtained with this heat pump, use another heating appliance in conjunction with this unit. When the outdoor temperature is low, frost or ice may form on the outdoor heat exchanger coil, reducing the heating performance. When this happens, a microcomputer-controlled defrosting system operates. At the same time, the fan on the indoor unit stops (or runs at very low speed in some cases) and the ??STANDBY??indicator appears on the display until defrosting is completed. [. . . ] Improper temperature settings Room is exposed to direct sunlight in cooling mode. Too much heat sources in room in cooling mode. Too many people in room in cooling mode. Use minimum heat sources and in a short time. [. . . ]