User manual PANASONIC TC-21S70M

[. . . ] Attention to Article 820­40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Read these instructions and apply them with your LCD TV. For example: Avoid placing it near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. Unplug this LCD TV from the wall outlet before cleaning. [. . . ] do not spill water on the remote control. Do not place objects between the remote control and remote control receiver. Do not use remote controls for other equipment at the same time. If the TV does not operate even when operating the remote control from a close range, it is time to replace the batteries. To clean this unit, wipe with a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth dipped in a soap and water solution or a weak detergent solution. ⷠUse eyeglass cleaner to remove stubborn dirt from the LCD. ⷠNever use alcohol, paint thinner or benzine to clean this unit. ⷠBefore using a chemically treated cloth, read the instructions that came with the cloth carefully. CAUTION : If water or similar substances get inside the monitor via the liquid crystal panel surface, a malfunction may result. Grasp the opening and initially pull the cover slightly towards yourself to disengage the claws (at 2 points on both the left and right). Usage of AC adapters other than specified may cause malfunctions. POWER-OFF: No light Example: The screen below is displayed for a while after the TV is turned on. Press the POWER button on the remote control to turn the TV off: Red (standby) Press the POWER button on the remote control to turn the TV on: Green Playing a VCR or other peripheral equipment DVD player To Audio output This equipment can also be connected to the rear terminals. Turning the power on and switching input modes The input mode changes each time this button is pressed. Note: When the remote control is unavailable, input modes can also be switched using the TV/VIDEO button on the TV set. Operate your Remote control pointed to the Remote control sensor (Within about 6 meters in front of the TV set. ) Power button Press to turn this set ON or OFF. (See page 13) Note: The LCD TV's power cord must first be plugged into the wall outlet and then turned on at the Main POWER switch. Changes to the next channel up Moves cursor upward during menu mode. Reduces volume Increases volume Moves cursor to Moves cursor to the right during the left during menu mode. TV/VIDEO button The input mode changes each time this button is pressed. [. . . ] Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, consult your dealer for instructions. Symptom Power supply does not go on Remote control cannot be operated Cause and remedy Is power plug unplugged from the outlet? ⷠIf power willsupply on with the remote control, is the power supply of the TV "Off"? [. . . ]