User manual PANASONIC TH-50PHD5VEX

[. . . ] If the product is not correctly installed and adjusted, damage may result to the product. Make sure that all safety factors regarding strength of installation are observed. · If the installation strength is insufficient, the display may fall down and personal injury may result. [. . . ] This model does not include the bolts needed to mount the bracket to the wall. Please purchase screws suitable for the material (wood, steel frame, concrete, etc. ) of the wall on which the bracket and Plasma Display are to be mounted. Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily accessible. Provide adequate ventilation so that the temperature around the display does not rise above 40 . If there is insufficient movement of air inside the display, heat may build up inside the display, and fire may result. This Plasma Display is for use only with the following optional accessories. Use with any other type of optional accessories may cause instability which could result in the possibility of injury. (All of following accessories are manufactured by Matsushita Electric Industrial Co. , Ltd. ) · Wall-hanging bracket (vertical) --- TY-WK42PV1 · Wall-hanging bracket (for PDP with PC) --- TY-WK42PRE1 (for U. S. A only) Always be sure to ask a qualified technician to carry out set-up. Make sure that you have the following accessory. There is following accessory in addition to the accessories indicated by the TH50PHD3, TH-50PHD30, TH-50PHD5, TH-42PWD4, TH-42PWD5 operating instructions. Fixing screw ( M5-35). . . . . . . . . . . . . . . . . . . . . . . . 2 3 Installation procedure 1. Check the strength of the installation location. The wall-hanging bracket weights approx. 6 kg (13. 2 lbs. ), a 50-inch display weights approx. 45 kg (99. 2 lbs. ), a 42-inch display weights approx. Using the bracket dimensions shown in the diagram at right, confirm that the 6 locations for mounting the bracket to the wall are able to bear the combined weight. If the wall is not strong enough, reinforce it. NNotee ot Dimensions of the wall-hanging bracket (sold separately) 20 (25/32) 490 (19 19/64) 450 (17 23/32) Units: mm ( 20 (25/32) 15 (19/32) ): inch 30 (1 3/16) 50 (1 31/32) 100 (3 15/16) Used for routing wires behind a wall 450 (17 23/32) 15 (19/32) 450 (17 23/32) 930 (36 /8) 5 · The wall-hanging bracket has 24 installation holes. If the wall material is not strong enough to install the display using six installation holes, use some of the spare holes. [. . . ] The display cannot be installed in the correct position if the bolt is overtightened. Fixing screw * Note: In this case, the wall-hanging bracket fixing screw (M5 x 135) is not used. NNotee ot Fixing screw · Use commercially available bolts which suit the wall materials for installation to the wall. 4 50 (1 31/32) 3. Attach the insulation spacers to the display. Remove the four bolts from the display. Remove M8 bolts In the holes that previously held the 4 M8 bolts, insert the insulating spacer, toothed pan washer, and pan head bolt with hex socket (4 each) that came with the wall-hanging bracket. Pan head bolt with hex socket Fixing Toothed pan washer Insulating spacer 4. Install the display to the wall-hanging bracket. Position the display so that the power switch is located at the bottom. Top holes Insulating spacer Push the upper insulating spacers on the display into the notches at the top of the wall-hanging bracket until they are hooked in, then lower the display into place. [. . . ]