User manual PANASONIC TH-80LFB70U

[. . . ] Do not place containers with water (flower vase, cups, cosmetics, etc. ) No naked flame sources, such as lighted candles, should be placed on / above the set. 3) Do not remove the earthing pin on the power plug. This apparatus is equipped with a three pin earthing-type power plug. [. . . ] € Batteries must not be exposed to excessive heat such as sunshine, fire or the like. Cleaning and maintenance The front of the display panel has been specially treated. Wipe the panel surface gently using only a cleaning cloth or a soft, lint-free cloth. € If the surface is particularly dirty, wipe with a soft, lint-free cloth which has been soaked in pure water or water in which neutral detergent has been diluted 100 times, and then wipe it evenly with a dry cloth of the same type until the surface is dry. € Do not scratch or hit the surface of the panel with fingernails or other hard objects, otherwise the surface may become damaged. Furthermore, avoid contact with volatile substances such as insect sprays, solvents and thinner, otherwise the quality of the surface may be adversely affected. If the cabinet becomes dirty, wipe it with a soft, dry cloth. € If the cabinet is particularly dirty, soak the cloth in water to which a small amount of neutral detergent has been added and then wring the cloth dry. Use this cloth to wipe the cabinet, and then wipe it dry with a dry cloth. € Do not allow any detergent to come into direct contact with the surface of the Display. If water droplets get inside the unit, operating problems may result. In that case, remove static electricity and the noise source that may cause problems with an antistatic mat, and re-connect the DIGITAL LINK and the wired LAN. • In rare cases , the LAN connection is disabled due to static electricity or noise. In that case, turn off the power of the Display and the connected devices once and then re-turn on the power. The Display may not work properly due to strong radiowave from the broadcast station or the radio. € If there is any facility or equipment, which outputs strong radiowave, near the installation location, set up the Display at a location sufficiently far from the source of the radiowave. Or, wrap the LAN cable connected to the DIGITAL LINK terminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends. LCD Display Declaration of Conformity (DoC) “Hereby, Panasonic Corporation declares that this Display is in compliance with the essential requirements and other relevant provisions of the Directive 1999/5/EC. € If you want to get a copy of the original DoC of this Display, please visit the following website: http://www. De Authorized Representative: Panasonic Testing Centre Panasonic Marketing Europe GmbH Winsbergring 15, 22525 Hamburg, Germany This Display is intended to be used in the following countries. Albania, Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Italy, Iceland, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey, United Kingdom The wireless LAN feature of this Display shall exclusively be used inside buildings. 3 Paste the washer to a screw hole for the pen stand. [. . . ] The setting changes to 30 minutes, 60 minutes, 90 minutes and 0 minutes (off timer cancelled) each time the button is pressed. 30 min 60 min 90 min 0 min (Cancel) When three minutes remain, “Off timer 3 min” will flash. The off timer is cancelled if a power interruption occurs. AUTO SETUP button Automatically adjusts the position/ size of the screen. [. . . ]