User manual PANASONIC TH-80LFB70W

[. . . ] ) No naked Àame sources, such as lighted candles, should be placed on / above the set. 3) Do not remove the earthing pin on the power plug. This apparatus is equipped with a three pin earthing-type power plug. This plug will only ¿t an earthing-type power outlet. [. . . ] If the power cable is damaged, have it repaired at your local Panasonic dealer. If the Display is not going to be used for any prolonged length of time, unplug the power supply plug from the wall outlet. To prevent the spread of ¿re, keep candles or other open Àames away from this product at all times. If problems occur during use If a problem occurs (such as no picture or no sound), or if smoke or an abnormal odour starts to come out from the Display, immediately unplug the power supply plug from the wall outlet. € If you continue to use the Display in this condition, ¿re or electric shock could result. After checking that the smoke has stopped, contact your local Panasonic dealer so that the necessary repairs can be made. Repairing the Display yourself is extremely dangerous, and shall never be done. If water or foreign objects get inside the Display, if the Display is dropped, or if the cabinet becomes damages, disconnect the power supply plug immediately. € A short circuit may occur, which could cause ¿re. Contact your local Panasonic dealer for any repairs that need to be made. 4 Safety Precautions CAUTION When using the LCD Display English Do not bring your hands, face or objects close to the ventilation holes of the Display. Usage of a chemical cloth • Do not use a chemical cloth for the panel surface. € Follow the instructions for the chemical cloth to use it for the cabinet. 5 Accessories Accessories Supply English Check that you have the accessories and items shown Operating Instruction book CD-ROM (Operating instructions) Remote Control Transmitter N2QAYB000691 Batteries for the Remote Control Transmitter (R6 (UM3) Size × 2) Power supply cord Clamper × 1 TMME289 Remote Control Batteries Requires two R6 batteries. Pull and hold the hook, then open the battery cover. + + - Helpful Hint: For frequent remote control users, replace old batteries with Alkaline batteries for longer life. Precaution on battery use Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter. Always use new batteries when replacing the old set. Do not combine a used battery with a new one. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”). Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. Battery replacement is necessary when remote control acts sporadically or stops operating the Display set. [. . . ] Customer’s Record The model number and serial number of this product can be found on its rear panel. You should note this serial number in the space provided below and retain this book, plus your purchase receipt, as a permanent record of your purchase to aid in identi¿cation in the event of theft or loss, and for Warranty Service purposes. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. [. . . ]