User manual PANASONIC TX-15M2T

[. . . ] ` CABINET AND PICTURE TUBE CARE Remove the mains plug from the wall socket. The cabinet and picture tube can be cleaned with a soft cloth moistened with mild detergent and water. Do not use solutions containing benzol or petroleum. TV sets can produce static electricity, care must be taken whenever touching the TV screen. [. . . ] Replacement fuse covers can be purchased through your local Panasonic dealer. The plug fitted to this appliance incorporates a mains filter circuit. If this is removed or replaced with a non-filtered plug this television will no longer meet the European standards for Electromagnetic Compatibility (EMC). If the fitted plug is unsuitable for the socket outlet in your home an appropriate adapter should be used. Nonetheless, if the fitted plug is replaced, the fuse should be taken out and the cut-off plug disposed of safely. There is danger of severe electrical shock if the cut off plug is inserted into any 13 amp. If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a qualified electrician. How to replace the fuse (for plug type shown in example 1) : Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit securely into the mains plug (see example 1). How to replace the fuse (for plug type shown in example 2) : Lift open the fuse compartment, in the mains plug, with a screwdriver, and replace the fuse, then press the fuse cover down securely (see example 2). Example 1. IMPORTANT :-- The wires in the mains lead of this appliance are coloured in accordance with the following code :-BLUE : NEUTRAL BROWN : LIVE As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your plug, proceed as follows :-1. If connecting the TV using an RF cable only, proceed to option 1. If connecting the TV to VCR or Satellite Receiver using Scart and RF cables, proceed to option 2. If connecting the TV both to Satellite Receiver and VCR using Scart and RF cables, proceed to option 3. 1. Connection of TV using an RF cable only 2. Connection of TV to VCR or Satellite receiver using Scart and RF cables Mains Socket Mains Socket Aerial Input socket Mains Socket Aerial Input socket AV Scart sockets Aerial Input socket Aerial Outpu socket VCR or SATELLITE RECEIVER 3. Connection of TV to VCR and Satellite receiver using Scart and RF cables Mains Socket Mains Socket Aerial Output socket TV Scart socket SATELLITE RECEIVER TV VCR Scart socket Aerial Input socket AV Scart socket Mains Socket VCR AV Scart socket Aerial Input socket Aerial Input socket Aerial Output socket RF Connections Connect an RF cable to the Aerial In socket of the Satellite Receiver. Connect an RF cable from the RF socket of the Satellite Receiver to the RF In socket of the VCR. Connect an RF cable from the RF Out socket of the VCR to the TV Aerial In socket. Notes : Additional equipment and cables are not supplied. Further details of Audio/ Video connections can be found on page 20. Further information for VCR and Satellite Receiver installation with this TV can be found on page 18. 6 QUICK START GUIDE 1 Ensure that the VCR is in Standby mode. [. . . ] If the TV has not been programmed for you then Auto setup will begin. TV stations will be located, sorted into order and stored ready for use. *2 3 Owner ID As an added feature, this TV has the option of adding a security code (Owner ID) and personal details into its memory, so that in the unfortunate event of theft it will help the Police to trace the owner. 4 Enter NAME, HOUSE NUMBER and POSTCODE. If a 4 digit PIN NUMBER was entered above, you will be taken automatically to the NAME line. [. . . ]