User manual PANASONIC TX-32LE8FSA

[. . . ] 4 Fitting remote control batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Cable cover removal and fitting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 How to open the front cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 How to use the LCD stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] CH44 CH51 CH41 CH47 CH37 Name ABC XYZ FTP 123 456 Add Lock Off Off Off Off Off Move Download Delete 14 Tuning menu ­ Programme edit Press the MENU button. Access Setup menu. 1 2 5 8 0 3 6 9 MENU OK Move to Tuning menu. Access Programme edit. 4 7 C N TV Move to choose programme position (e. g. , Prog. Make required change, e. g. , moving a programme channel (see the relevant procedure below). Press the EXIT button at any time to go back to watching TV. Press the OK button after having adjusted some features to store the new settings. EXIT OK Adding / deleting a programme channel Move the cursor to the programme to be deleted or added. Press the Green button to add a programme channel to the programme position, or the Red button to delete one. Press the same button again to confirm your decision. Programme edit Prog. CH44 CH51 CH41 CH47 CH37 Name ABC XYZ FTP 123 456 Add Lock Off Off Off Off Off Cancel Red Green Moving a programme channel Move the cursor to the programme to be moved. Press the Yellow button. Yellow Programme edit Prog. CH44 CH51 CH41 CH47 CH37 Name ABC XYZ FTP 123 456 Lock Off Off Off Off Off Confirm Cancel Choose the new position for the programme channel. Press the TV/AV button to move between Change programme and Search. Press the ­/ or +/ button to change programme position or start search. When the desired station is found, press the STR button to store. Repeat above procedure to tune additional programme positions. Press the F button at any time to go back to watching TV. STR F TV/AV 1 CH12 Manual tuning -, + TV / AV STR F 01 STR F : : : : Search Move cursor To store To exit 99:21 -/ +/ 41 TV / AV 18 Owner ID Owner ID allows you to enter a security code(Owner ID) and personal details into its memory, so that in the unfortunate event of theft it will help the police to trace the owner. If you wish to check the personal details already entered into the TV (except your PIN number), press the F button (Front panel) and hold for 6 seconds(initially the volume level function will appear, as you continue to hold down the F button it will disappear again, and the Owner ID information will appear). The details already entered are displayed on screen and will disappear after a few seconds. If Owner ID information was not entered when you switched on your TV for the first time or it is necessary to alter some of the information, Owner ID can be re-accessed via the Setup menu. STR F TV/AV Press the MENU button. Access Owner ID. MENU OK 1 4 7 C 2 5 8 0 3 6 9 N If the Owner ID has previously been set, enter the PIN NUMBER (using 0 to 9 on the remote control) followed by the OK button to proceed, this will take you to the NAME option. If no Owner ID has previously been set, enter the required 4 digit Owner ID PIN NUMBER (using 0 to 9 on the remote control). If a 4 digit PIN NUMBER was entered above, you will be taken automatically to the NAME line. [. . . ] - in 15 Red earth 13 Green in 11 Green earth 9 Blue in 7 Blue earth 5 Audio out (L) 3 Audio out (R) 1 20 18 16 14 12 10 8 6 4 2 Chrominance earth Luminance earth CVBS in (video) Earth Status RGB Earth -Q-Link data Status CVBS Audio in (L) Audio earth Audio in (R) AV4 - Pins 15 and 20 are dependent on AV4 S-VHS / VIDEO switching. 32 Input signal that can be displayed Applicable input signal for Component (Y, PB, PR) and HDMI ( Mark) Signal name 525 (480) / 60i 525 (480) / 60p 625 (576) / 50i 625 (576) / 50p 750 (720) / 60p 750 (720) / 50p 1, 125 (1, 080) / 60i 1, 125 (1, 080) / 50i Horizontal frequency (kHz) 15. 73 31. 47 15. 63 31. 25 45. 00 37. 50 33. 75 28. 13 Vertical frequency (Hz) 59. 94 59. 94 50. 00 50. 00 60. 00 50. 00 60. 00 50. 00 Component HDMI Note: Signals other than above may not be displayed properly. Maintenance To clean this set, wipe with a soft, dry cloth. Neutral If the surfaces are extremely dirty, use a soft cloth dipped in soap-and-water solution or a detergent weak detergent solution. · Use eyeglass cleaner to remove stubborn dirt from the LCD. · Never use alcohol, paint thinner or benzine to clean this set. [. . . ]