User manual PANASONIC TYCE42PS7

[. . . ] Do not fit at any locations subject to humidity, dust, smoke, steam or heat. This may cause heat to build up inside the plasma display, resulting in a fire. Do not hang from or hang objects on the plasma display or ceiling-hanging bracket. Do not block the space around the plasma display when using the ceiling-hanging bracket. [. . . ] ) 3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the ceiling-hanging bracket. Do not allow long-term contact with rubber, vinyl products or the like. Do not subject it to a strong force or impact. This bracket is intended for only Panasonic plasma display models (See page 96-97). Ceiling unit (1) Bolt for fixing upper and lower sections (2) M8 × 12 Screw for securing unit (2) M5 × 35 Through bolt for fixing upper and lower sections (1) M8 × 100 Allen head countersunk screw (4) M8 × 32 [The images shown in this manual are for illustrative purpose only. This equipment is a ceiling unit to suspend the Plasma Display from a ceiling structure for viewing purposes. The ceiling unit must not be installed in any locations other than ceiling structures with sufficient strength. To ensure correct plasma display performance and prevent trouble, do not fit at any of the following locations. Where there is a risk of exposure to vibration or impact · Near high-voltage wires or dynamic power supplies · Near sources of magnetism, heat, water vapor or soot · locations exposed to air blown from heating equipment · Where droplets of condensation from an air conditioner or other unit may form Fit using techniques suited to the structure and materials of the fitting location. When installing the ceiling unit to a ceiling structure, use structural components appropriate to the material of the structure, and an installation method. Align the height adjustment holes of lower section of the ceiling unit with the holes of the upper section. Pass a spring washer over the through bolt for fixing upper and lower sections and pass the bolt through the ceiling unit adjustment holes. Then, temporarily tighten with a washer pan nut . M8 assembly bolt White line Hidden side Bolt for fixing upper and lower sections (M8-12) No more than four height adjustment holes should be visible. ) Temporarily tighten the two M8 assembly bolts removed in unit preparation. Tighten firmly using the two bolts for fixing upper and lower sections . Attaching the insulation spacers Place the front surface of the plasma display on a clean cloth that has no dirt or foreign objects on it, and follow the procedure below. If the plasma display has any protruding parts, take care not to scratch or damage them. Remove the four caps from the plasma display using a Phillips head screwdriver. note · Keep the caps that were removed in a safe place. (They will be required if you use the pedestal. [. . . ] Bundle the cords and cables connected to the terminals at the bottom of the back side of the plasma display, and secure them using the two clampers . Do not bunch the power cord together with other cords and cables. Return the ceiling unit angle to 0º, then remove the two screws for securing unit on the left and right sides of the ceiling unit. Lift the lower part of the plasma display, pull outward and lift upward. [. . . ]