User manual PANASONIC TY-ER3D4SE

[. . . ] TY-ER3D4ME TY-ER3D4SE ENGLISH DANSK NEDERLANDS FRANÇAIS DEUTSCH ITALIANO PORTUGUÊS ESPAÑOL SVENSKA TÜRKÇE GUARANTEE This product cannot and must not be used as sunglasses. tQZJ404 Thank you for purchasing a Panasonic product. Before using this product, be sure to read "Safety Precautions" and "Using Precautions" ( pages 2 - 6). Before operating this product, please read the instructions carefully, and save this manual for future use. [. . . ] 6 Identifying Controls Power switch Indicator lamp ENGLISH Charging port (DC IN) Power switch ON/OFF MODE Slide the tab to the ON/OFF position to switch the power on/off. Slide the tab once to the MODE position to change the mode between 3D and 2D. This is also used when registering the 3D Eyewear on the television. For details on registration, refer to the Registration page. ( page 9) Indicator lamp Lights or flashes during use or charging to show the status of the rechargeable battery and the registration. (continued overleaf) 7 Indicator lamp status Indicator lamp Lights red for 2 seconds when turned on Flashes red 5 times when turned on Flashes red and green alternately Flashes green once every 2 seconds Lights green for 3 seconds ENGLISH Flashes red 3 times Status Sufficient battery level Low battery level Under registration Under reconnecting to the TV Registration or reconnecting is successfully completed. Automatically power off (Registration or reconnecting fails or connection is lost) 3D mode is selected 2D mode is selected Flashes red once every 2 seconds when in use Flashes red twice every 4 seconds when in use Charging Charging the 3D Eyewear USB connector Micro USB connector Connect the 3D Eyewear with the included charging cable to the television, then switch on the television. When the indicator lamp turns off, charging is complete. Refer to the specifications on page 14 for the approximate charging time. nOTE · Charge the 3D Eyewear before using the first time after purchase or after long periods of disuse. Be sure to turn the television power on when charging. The battery will not be charged when the television power is off. 8 Registration First Registration Perform the First Registration when the 3D Eyewear is used for the first time. Slide the tab from the OFF position to the ON position. The 3D Eyewear will power on and start registration. Place the 3D Eyewear within 50 cm from the TV while registration in progress. The green LED lights on the 3D Eyewear for 3 seconds when the registration is successfully completed. After first registration, the 3D Eyewear will reconnect with the TV automatically when 3D Eyewear is powered on near the TV in 3D mode. Registration Again When connection with registered TV fails, or when using with another TV, re-register the 3D Eyewear. Within 50 cm from the TV, hold the tab on the MODE position for more than 2 seconds. The green LED lights for 3 seconds when the registration is successfully completed. * If the registration failed, the 3D Eyewear will power off. [. . . ] The 3D Eyewear may not operate correctly at the outside of the viewing range. These logos indicate products that are compatible with active shutter 3D glasses technology standards licensed by the Full HD 3D Glasses Initiative. The RF logo indicates products that operate on the wireless system, and can be used with any TV that has the same logo. "Full HD 3DTM" Logo indicates compatibility between TV products and 3D Eyewear which are compliant with the "Full HD 3D GlassesTM" format, and does not indicate picture quality of 3D image which should be depend on the quality of TV products. [. . . ]