User manual PANASONIC TYFB10WPE

[. . . ] Viewing 3D Content Do not use the 3D Eyewear if you have a history of over-sensitivity to light, heart problems, or have any other existing medical conditions. Stop using the 3D Eyewear immediately if you feel tired, discomfort, or any other uncomfortable sensation. Take an appropriate break after viewing a 3D movie. Take a break of between 30 - 60 minutes after viewing 3D content on interactive devices such as 3D games or computers. [. . . ] Do not use 3D Eyewear outside the specified usage temperature range ( page 13). If the room is lit by fluorescent lights (50 Hz) and light appears to flicker when using the 3D Eyewear, switch off the fluorescent light. 3D content will not be correctly visible if the 3D Eyewear is worn upside down or back-to-front. Do not wear the 3D Eyewear when watching anything other than 3D images. Other kinds of displays (such as computer screens, digital clocks, or calculators etc. ) may be difficult to see while wearing the 3D Eyewear. Using Precautions ENGLISH - 5 Identifying Controls (Shown as TYFB10WPE) Infra-red receiver Receives infra-red signals from the television. The liquid crystal shutter open/close timing is controlled by receiving infra-red signals from the television, which provide 3D expression of the images. If the eyewear stops receiving infra-red signal from the television, the power automatically switches off after 5 minutes. Liquid Crystal Shutter (lens) Controls the images for 3D viewing. The left and right liquid crystal shutters are alternately opened and closed in time with the left side and right side images that are alternately displayed on the television to achieve the 3D effect. Charging port Power switch (bottom side of 3D Eyewear) Connect the charging cable. ( page 9) Switches on the 3D Eyewear power. The 3D Eyewear is turned on by setting the power switch to "ON". Set the power switch to "OFF" to turn off the 3D Eyewear. Indicator lamp Lights or flashes during use or charging to show the status of the rechargeable battery. Battery status shown by indicator lamp Power/indicator lamp status Lights for 2 seconds when turned on Flashes 5 times when turned on Flashes once every 2 seconds when in use Lights continuously when off Lamp off Battery status Sufficient battery level Low battery level Operating normally Charging Power off 6 - ENGLISH Accessories < > indicates the quantity. 3D Eyewear case ·······················<1> Charging cable ···························<1> Ferrite core·································<1> Attaching Ferrite Core Be sure to attach the provided ferrite core to the charging cable to reduce interference or electrical noise. Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off. Do not dunk the 3D Eyewear in liquid such as water when cleaning. Avoid storing the 3D Eyewear in hot or highly humid locations. NOTE · As the liquid crystal shutters (lens) are fragile and easily broken, be very careful when cleaning them. ENGLISH - 9 Disposal A lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations. When disposing this product, disassemble properly by following the procedure on the next page, and remove the internal rechargeable battery. Do not disassemble this product except when disposing of it. Danger As the rechargeable battery is specifically for this product, do not use it for any other device. Do not charge the removed battery. Do not throw the battery in a fire, or apply heat to it. Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it. Do not let the wires touch any other metal or each other. Do not carry or store the battery with a necklace, hair pin, or the like. Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun. [. . . ] Are there any objects between the eyewear and television?Is there a sticker or other such item blocking the infra-red reception section on the 3D Eyewear?If the eyewear stops receiving infra-red signal from the television, the power automatically switches off after 5 minutes. Check that there are no objects blocking the path between the television and 3D Eyewear. [. . . ]