User manual PANASONIC TY-KPLASMA600

[. . . ] Made For Panasonic Plasma Wall-Hanging Bracket TYWKPLASMA600 (For list of applicable models see page3) Assembly Instructions Foreword / Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the wall material is not sufficiently sound to support the unit using 6 holes suggested then use as many more as considered necessary. The wall hanging bracket weighs approximately 6kg and the display units weigh between 28kg and 53kg depending on the model. Please refer to the installation diagrams specific to your model, check the strength of the wall at six locations and add reinforcements if any of these locations are not strong enough. B Measure and Mark 1. Select an installation site with an area suitable for your plasma, ensuring that there is room for a 100mm clearance from the top of the panel. Establish where you wish the top centre of the Plasma to be. Measure and mark B mm (please refer to specific `installation diagram' ­ value B) down from this point. This is now the top centre fixing point. Drill and fasten an M6 screw / bolt into this top centre hole. Hang the wall bracket on this fixing, using the top centre keyhole ­ gently tighten. Use a spirit level to achieve the correct horizontal alignment of the wall hanging bracket. Mark the remaining holes at the positions shown below. Remove the wall bracket and drill the marked 5 holes. Units:mm WALL INSTALLATION HOLES (6 locations) 4 C Hanging the wall bracket Note: It is suggested that commonly available M6 wall fixing bolts are used to secure the wall bracket. [. . . ] Attaching the display unit to the wallhanging bracket 1 2 Lift the display unit so that the upper mounting spacers at the back fit into the notched indentations at the top of the wallhanging bracket, and then lower the display unit into place. i) Lift the display unit slightly and insert the lower mounting spacers at the back of the display unit into the lower cut-outs in the wall-hanging bracket. ii) Lower the display unit into the lower notched part of the cut outs. iii) Attach the two security screws 6 Removing the display unit 1) Remove the security screws 2) Lift the display slightly 3) At the same time, pull the bottom half away to detach the lower mounting spacers 4) Lift the display away from the wall-hanging bracket 7 [. . . ]