User manual PANASONIC TY-LA1000

[. . . ] Lamp Replacement CAUTION: Because of the possibility of injury, strictly follow the replacement procedure below. This product has a High Intensity Discharge (HID) lamp that contains a small amount of mercury. Disposal of these materials may be regulated in your community due to environmental considerations. [. . . ] Then, loosen the lamp cover screw by using a screwdriver. Lamp cover handle Screwdriver and 5Insert the new lamp unit being careful of the insertion direction. · Press on the arrow mark making sure insertion is done correctly. LAMP indicator POWER button /POWER indicator the Lamp 6ReplaceaTighten theunit and cover screws. lamp unit/cover screw with screwdriver. · Properly dispose of old lamp. 3When resetis procedure complete, the LAMP TIME WAS RESET TO 0. screen on the right will appear. EXIT · Please wait more than one hour for lamp replacement. [If you need to replace the lamp more urgently] · The Projection display has a forced cooling feature. After the POWER button is turned OFF, and during the first minute of the normal cooling fan operation, press the VOL+ button on the projection display and button on the remote control at same time for more than 5 seconds. The cooling fan operates for about 10 minutes. The LAMP indicator flashes red 5 times every 5 seconds. LSQC0334 Note When lamp time reset is finished, the LAMP indicator goes out. Lamp cover screw CAUTION: [Under no circumstance should you touch the actual bulb. ] At this high operating temperature the natural oil on your finger can cause the glass to weaken where touched and the bulb can crack or explode. Note Attach the lamp unit and lamp unit housing door securely. If the lamp unit and lamp unit housing door are not attached securely, the protective circuit will be activated and the lamp will not turn on. 7Replace the Front cover. PANASONIC CONSUMER ELECTRONICS COMPANY, DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA One Panasonic Way Secaucus, New Jersey 07094 PANASONIC SALES COMPANY, DIVISION OF MATSUSHITA ELECTRIC OF PUERTO RICO, INC. , Ave. 9. 5 San Gabriel Industrial Park Carolina, Puerto Rico 00985 Panasonic Lamp Unit Limited Warranty Limited Warranty Coverage (LAMP Only) If your Lamp unit does not work properly because of a defect in materials or workmanship, Panasonic Consumer Electronics Company or Panasonic Sales Company (collectively referred to as "the warrantor") will, for the length of the period indicated below, which starts with the date of original purchase ("warranty period"), replace it with a new lamp unit. For ninety (90) days ­ In exchange for defective Lamp Unit You must Mail-In your Lamp unit during the warranty period. This warranty only applies to products purchased and serviced in the United States or Puerto Rico. This warranty is extended only to the original purchaser of a new product which was not sold "as is". Limited Warranty Limits And Exclusions This warranty ONLY COVERS failures due to defects in materials or workmanship, and DOES NOT COVER normal wear and tear or cosmetic damage. The warranty ALSO DOES NOT COVER damages which occurred in shipment, or failures which are caused by products not supplied by the warrantor, or failures which result from accidents, misuse, abuse, neglect, mishandling, misapplication, alteration, faulty installation, set-up adjustments, misadjustment of consumer controls, improper maintenance, power line surge, lightning damage, modification, or commercial use (such as in a hotel, office, restaurant, or other business), rental use of the product, service by anyone other than a Factory Servicenter or other Authorized Servicer, or damage that is attributable to acts of God. THERE ARE NO EXPRESS WARRANTIES EXCEPT AS LISTED UNDER "LIMITED WARRANTY COVERAGE". [. . . ] LSQC0334 Mail-In Service For assistance in obtaining service in the United States please contact: Panasonic Services Company Panasonic Plus Department 20421 84th Avenue South Kent, WA 98032 Phone: 1-800-833-9626 Fax: 1-800-237-9080 If a Lamp unit defect occurs during the warranty period the purchaser will be required to furnish a sales receipt/proof of purchase indicating date of purchase. Also, purchaser will be responsible for shipping the Lamp unit to the above address. For assistance in Puerto Rico call Panasonic Sales Company (787)-750-4300 or fax (787)-768-2910. [. . . ]