User manual PANASONIC TY-LA1500

[. . . ] For disposal or recycling information please contact your local authorities, or the Electronics Industries Alliance: <http://www. eiae. org. > 3 Remove the Lamp cover screws. First read caution and warning labels on lamp cover. Then, remove the lamp cover screws (2) by using a screwdriver. Lamp cover screws 5 Insert the new lamp unit being careful of the insertion direction. [. . . ] The cooling fan operates for about 10 minutes. The LAMP indicator flashes red 5 times every 5 seconds. Then, grasp the lamp unit as shown in the diagram, and slowly remove from the projection display. · Do not drop, as the impact of dropping may cause the lamp to explode. Lamp unit screws 7 Replace the left Speaker cover. Be sure the power cord is plugged into a properly grounded wall outlet. Then, press the POWER button on the projection display or the remote control to turn the power on. While pressing the VOL- button on the projection display, hold down the PIP button on the remote control at same time for more than 5 seconds. Air Filter Replacement The replacement lamp comes with an air filter. When replacing the lamp, also replace the air filter at the same time. 2 Note For the procedure to clean the air filter, please refer to the operating instructions. and · Air Filter replacement procedure 1 Remove the Air Filter unit Grasp the indented portion of the air filter and pull it out of the projection display. Lamp unit handle WARNING: The lamp may be hot. CAUTION: · High-pressure lamp may explode if improperly handled. · Danger of injury due to glass fragments. Indent 3 2 Remove the left Speaker cover. Place your fingertips under the left speaker panel and pull it from the projection display. When reset procedure is complete, the screen on the right will appear. L AMP T I ME WAS RE S E T TO 0 . RECALL EXIT Note · When lamp time reset is finished, the LAMP indicator goes out. LSQC0291 PANASONIC CONSUMER ELECTRONICS COMPANY, DIVISION OF PANASONIC CORPORATION OF NORTH AMERICA One Panasonic Way Secaucus, New Jersey 07094 PANASONIC PUERTO RICO, INC. , Ave. 9. 5 San Gabriel Industrial Park Carolina, Puerto Rico 00985 Panasonic Lamp Unit Limited Warranty Limited Warranty Coverage (LAMP Only) If your Lamp unit does not work properly because of a defect in materials or workmanship, Panasonic Consumer Electronics Company or Panasonic Puerto Rico (collectively referred to as "the warrantor") will, for the length of the period indicated below, which starts with the date of original purchase ("warranty period"), replace it with a new lamp unit. For One (1) year ­ In exchange for defective Lamp Unit You must Mail-In your Lamp unit during the warranty period. This warranty only applies to products purchased and serviced in the United States or Puerto Rico. [. . . ] If a problem with this product develops during or after the warranty period, you may contact your dealer or Servicenter. If the problem is not handled to your satisfaction, then write to the warrantor's Consumer Affairs Department at the addresses listed for the warrantor. PARTS AND SERVICE WHICH ARE NOT COVERED BY THIS LIMITED WARRANTY ARE YOUR RESPONSIBILITY. Mail-In Service For assistance in obtaining service in the United States please contact: Panasonic Services Company Panasonic Plus Department 20421 84th Avenue South Kent, WA 98032 Phone: 1-800-833-9626 Fax: 1-800-237-9080 If a Lamp unit defect occurs during the warranty period the purchaser will be required to furnish a sales receipt/proof of purchase indicating date of purchase. [. . . ]