Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PANASONIC TY-LA2000. We hope that this PANASONIC TY-LA2000 user guide will be useful to you.
Lastmanuals help download the user guide PANASONIC TY-LA2000.
Detailed instructions for use are in the User's Guide.
[. . . ] PT-52DL10
21 Lamp Unit
®
Lamp Unit Operating Instructions
Troubleshooting
Before you call for service, determine the symptoms and make a few simple checks as shown below. Symptoms Power does not turn ON Checks Is the lamp unit cover fully installed? [. . . ] If abusing it, it may have a risk of explosion. Wear gloves when replacing the lamp unit. If replacing the lamp unit becomes necessary during the operation of the projection TV, follow the procedure below to turn off the power and wait until the lamp unit cools completely. Press the POWER button on the remote control unit. Wait for about 90 seconds until the cooling fan stops. * The lamp cooling fan will continue to operate for about 90 seconds after turning off the power. Do not unplug the power cord from the outlet until the fan has stopped. Avoid interrupting the power line such as by using circuit breakers or switchable power strips. After the cooling fan has stopped, turn off the MAIN POWER switch on the front of the projection TV. Unplug the power cord from the outlet.
Lamp unit replacement period
171
The lamp unit for the projection TV should be replaced after approximately 5, 000 hours of use in the normal usage mode.
·
Warning display after 5, 000 hours of use When the power has been turned off after over 5000 hours of continued use, LAMP REPLACE will be displayed for approximately 1 min. A warning message to urge the replacement of the lamp will be displayed in red at the center of the screen.
LAMP REPLACE
Resetting the counter
After replacing lamp, please make sure to undergo below procedure in order to reset the lamp lifetime counter.
CH
VOL
ACTION
VOL
Press down both VOLUME DOWN button on the unit and ACTION button on the Remote Control at the same time for more than 1 second.
VOLUME
CH
POWER
R-STAND BY G-POWER ON
LAMP TEMP
When successful, the 3 LED on the set's front panel (Power / Lamp / Temperature) will flash for 5 seconds.
PT-52DL10
PT-52DL10
Replacing the lamp unit
Remove Procedure
1 Remove the speaker grille. 3 Loosen the two screws securing the lamp unit. [. . . ] Do not touch these screws.
172
4 Pull out the lamp unit slowly. Lamp unit cover Lamp unit cover 4 Firmly install the speaker grille.
Lamp unit Tabs
Speaker grille [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PANASONIC TY-LA2000
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PANASONIC TY-LA2000 will begin.
