User manual PANASONIC TY-S42PX60W

[. . . ] If this is not done, the unit may fall over and become damaged, and personal injury may result. Do not climb up onto the pedestal or use it as a step. (Young children should be made particularly aware of this caution. [. . . ] If you use the pedestal whilst it is physically damaged, personal injury may result. If this is not done, the unit may fall over and become damaged, and personal injury may result. Keep the unit away from direct sunlight and heating equipment. Failure to do so may result in warping, deformation, or degradation of materials, and a loss of strength that may cause the equipment to fall over or break and cause injury. During setting-up, make sure that all screws are securely tightened. If suffi cient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the Plasma Display, and it might fall over and become damaged, and personal injury may result. Use the accessory parts for fall-prevention to secure the Plasma Display. If the unit is knocked or children climb onto the pedestal with the Plasma Display installed, the Plasma Display may fall over and personal injury may result. Parts for assembly (Be sure to check the parts before assembling) (1) Insert the two stand pins into the top of the stand base . (2) Firmly secure the stand pin fixing screws into bottom screw hole of the stand base . Arrow marks are displayed on the back cover at the locations shown below. (1) Insert the two stand poles into the stand base from the rear of the plasma display, and then use the stand pole fixing screws to secure the stand poles . With the cloth (2) Fold over the portion of the panel with notches and holes in it along the crease. (1) Slightly bend the light-blocking panel to form a U-shape and fit the ends into the gaps (right and left) between the stand pins and the plasma display. (2) Align the four holes in the light-blocking panel with the holes in the stand base, insert the (four) fixing pins , and push down hard on the tops of the fixing pins to lock them in place. Push both side hooks and pull out We recommend that measures are taken to prevent the Plasma display from falling over in such an event. [. . . ] * The information in this section is designed to reduce the risk of injuries caused by the Plasma display falling over during an earthquake, etc. However, no measure can guarantee protection against all earthquakes. Securely attach to a wall, pillar or similarly solid structural feature using separately- obtained products such as cords or chains of adequate strength. [. . . ]