User manual PANASONIC TYST08

[. . . ] (Be particularly careful that young children obey this caution. ) Do not use the pedestal if it has become bent or deformed for any reason. Doing so may cause the unit to fall over and become damaged, which may result in personal injury. When using the pedestal, do not block the space between the bottom surface of the plasma display and the floor surface. [. . . ] Do not use in places with high humidity. After prolonged use, the pedestal may warp or become deformed, reducing its strength. This may lead to the unit falling over and becoming damaged, which may also result in personal injury. When installing the plasma display, ensure there is at least a 10 cm (3. Two people are required to install and remove the display from the pedestal. During setting-up, make sure that all screws are securely tightened. If assembly is not performed correctly, the pedestal will not be able to support the weight of the display. This may result in the display falling over and becoming damaged, which may result in personal injury. Otherwise, the plasma display may fall off the wall and/or be damaged, possibly causing injury. Failure to do so may cause the unit to fall over and become damaged, which may result in personal injury. Unit installation screw (4) [ The images shown in this manual are for illustrative purpose only. Make sure you do not scratch the surface of the stand base. Align stand base with the stand poles on the left and right sides, and use the stand pole installation screws (4 screws) to attach the stand poles as shown in the diagram. Place the assembled pedestal with the rear side (side with the model nameplate attached) facing towards yourself, align the plasma display with the stand poles, insert the stand poles into the plasma display, and insert and tighten the unit installation screws (4 screws). Model Nameplate With the side that has the model nameplate attached facing you, insert the stand poles as far as possible into the plasma display. Unit installation screw (1 clamper) through the clip on the Connect the necessary wiring for the additional equipment, pass a clamper rear of the stand base, and bunch together all of the cords and cables as shown in the diagram. Do not bunch the power cord together with other cords and cables. Rear View While ensuring there is sufficient slack in the cord to minimize stress, firmly bind cables with the supplied clamper Binding the Cables Pass the tip of the clamper through the clip Pull Pull Bundle all cables tidily Pull the lock section of the clamper Anchor the plasma display to both the base and the wall surface. Anchoring to the base (2 belts) to the pedestal using screws (2 screws) through the Attach the overturn-prevention belts screw holes at both sides of the rear of the pedestal, and use the wood screws (2 screws) to anchor to the base. When attaching to the base, insert the wood screws into the prepared holes. [. . . ] When attaching to the base, insert the wood screws into the prepared holes. If there are no prepared holes, drill new holes to the center of the base board width. Locate the wood screw at the center of the material width. [For safety reasons, always use the overturn/fall prevention accessories] the equipment may overturn in the event of an earthquake etc. [. . . ]