User manual PANASONIC TYST09

[. . . ] Do not climb on or hang from the plasma display or mobile stand. Be particularly careful that young children obey this caution. Otherwise the unit may fall over and become damaged, and personal injury may result. Do not block the space between the bottom of plasma display and the floor when using the mobile stand. [. . . ] If the unit is extremely soiled, first wipe off soiling with a neutral detergent diluted in water, and then wipe with a dry cloth. Do not use cleaners such as benzene, thinner or furniture wax because they may cause paint peeling. (For information on cleaning the plasma display , see the plasma display's instruction manual. If using a chemically-treated cloth, follow the instructions supplied with the cloth. ) 3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the mobile stand. Do not allow long-term contact with rubber, vinyl products or the like. Do not subject it to a strong force or impact. To ensure correct plasma display performance and prevent trouble, do not fit at any of the following locations. Where there is a risk of exposure to vibration or impact · Near high-voltage wires or dynamic power supplies · Near sources of magnetism, heat, water vapor or soot · locations exposed to air blown from heating equipment · Where droplets of condensation from an air conditioner or other unit may form For the plasma display power supply plug, use a power supply outlet that can be reached easily. Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F). If a screw hole is stripped, use spare holes. The figure shows an example of fitting to the upper level (50 cm [19. Turn so the caution label of the readied shelf plate is on the back right, align the bracket for shelf plate screw holes and the support column inside right and left screw holes, and fasten with four screws for fitting bracket for shelf plate . (Tightening torque: 2 to 3 N· M) Fasten from the left and right of the outside of the support column with the two readied hexagon socket cap button bolts and cap nuts with flanges . Fasten with two hexagon socket cap button bolts and cap nuts with flanges through the bolt holes on the right and left sides of the upper level (50 cm [19. Remove the two hexagon socket cap button bolts on the left and right sides at the lower level position. Then fit the same way as in procedures and for fitting the upper level. Place the front surface of the plasma display on a clean cloth that has no dirt or foreign objects on it, and follow the procedure below. If the plasma display has any protruding parts, take care not to scratch or damage them. Remove the four caps from the plasma display using a Phillips head screwdriver. Keep the caps that were removed in a safe place. [. . . ] Therefore, always use the overturn/fall prevention accessories. * The details in this section indicate how to reduce any damage or injury caused by this equipment overturning or falling due to an earthquake. However, there is no guarantee that the overturn/fall prevention accessories will be effective in all earthquake situations. Remove the two screws for securing unit on the back of the top bracket for plasma display on the mobile stand. [. . . ]