User manual PANASONIC TY-ST50VX100

[. . . ] Before commencing work, carefully read these Instructions and the Manual for the plasma display to ensure that fitting is performed correctly. You may need them when maintaining or moving. Do not install in a location that cannot support the entire load. [. . . ] Keep the unit away from direct sunlight and heating equipment. Failure to do so may result in warping, deformation, or degradation of materials, and a loss of strength that may cause the equipment to fall over or break and cause injury. During setting-up, make sure that all screws are securely tightened. If suffi cient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the Plasma Display, and it might fall over and become damaged, and personal injury may result. Use the accessory parts for fall-prevention to secure the Plasma Display. If the unit is knocked or children climb onto the pedestal with the Plasma Display installed, the Plasma Display may fall over and personal injury may result. When installing or removing the plasma display and pedestal, ensure that the work is done by at least three persons. If more than three people are not present, the display may be dropped, and personal injury may result. 9 inches) at the top, left and right, and at least 7 cm (2. 8 inches) at the rear, and keep the space between the bottom of the display and the floor surface. Do not cover the air inlet holes and air outlet holes, or a fire may result. 1) If the unit is placed in direct sunlight or next to a stove, the light and heat may cause discoloration or deformation. 2) Cleaning Wipe the surfaces with a soft, dry cloth. If the unit is particularly dirty, clean it using a cloth soaked with water to which a small amount of neutral detergent has been added, and then wipe with a dry cloth. Do not use products such as solvents, thinner or household wax for cleaning, as they can damage the surface coating. (If using a chemically-treated cloth, follow the instructions supplied with the cloth. [. . . ] Carry out the work on a horizontal and level surface. View from the bottom Se till att det finns minst 10 cm ledigt utrymme ovanför, till höger och till vänster om skärmen, och minst 7 cm bakom den. Dålig ventilation kan leda till överhettning inuti skärmen och därmed risk för brand. [. . . ]