User manual PANASONIC TY-WK103PV9

[. . . ] If its strength becomes insufficient over the course of long-term use, the display may drop, possibly causing injury. Installation and removal should only be carried out by a qualified technician. If the bracket is installed incorrectly, the display may fall down and personal injury may result. [. . . ] If the unit is extremely soiled, first wipe off soiling with a neutral detergent diluted in water, and then wipe with a dry cloth. Do not use cleaners such as benzene, thinner or furniture wax because they may cause paint peeling. (If using a chemical wiping cloth, follow any precautions included. ) ) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the wallhanging bracket. ) Take care during installation as shocks can cause `panel cracks' to the plasma dispaly unit. Wall-hanging bracket Base unit (L) (1) Wall-hanging bracket Base unit (R) (1) English The wall-hanging bracket is for use in installing the Plasma Display to a vertical wall for viewing purposes. Do not use it for any type of installation other than vertical wall installation. In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display in any of the following places. Where there is a risk of exposure to vibration or impact · Near high-voltage wires or dynamic power supplies · Near sources of magnetism, heat, water vapor or soot · locations exposed to air blown from heating equipment · Where droplets of condensation from an air conditioner or other unit may form When installing this wall-hanging bracket unit, use a fixing method appropriate to the type of wall. Use commercially available bolts with a nominal diameter of 12 mm that are suited to the wall material (steel frame, concrete, etc. Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall. Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily accessible. Provide adequate ventilation so that the temperature around the display does not rise above 40 °C (104 °F). [. . . ] Insert the stand hooks (x) on the display into the notches of the wall-hanging brackets, and lower the display straight down. Securely tighten the safety catches (x) which were removed previously, using the safety catch anchoring screws. Safety catch anchoring screw Safety catch anchoring screw Be sure to tighten the left and right safety catches to prevent the display from detaching from the wall-hanging bracket. [. . . ]