User manual PANASONIC TY-WK32LX20W

[. . . ] ) This symbol indicates that the direction must be followed with caution. this symbol indicates that the direction is prohibited. This symbol indicates that the direction must always be followed. Be aware of safety factors concerning the mounting strength. [. . . ] ) 3) Do not affix adhesive tape or stickers. Doing so may dirty the surface of the wall mounting bracket. The wall hanging bracket is for use in attaching a LCD TV unit to a vertical wall for viewing. Do not fit to any surface other than a vertical wall. There is a lock mechanism on the left side of the unit, so keep a space of at least 300 mm (11 13/16 inches) between the LCD TV and the nearest wall. To ensure correct LCD TV performance and prevent trouble, do not fit at any of the following locations. Where there is a risk of exposure to vibration or impact · Near high-voltage wires or dynamic power supplies · Locations exposed to air blown from heating equipment Fit using techniques suited to the structure and materials of the fitting location. Use commercially available M6 screws suited to the wall surface material (wood, steel frame, concrete etc. Fit so there is no contact between the attachment screws or power cord and any metal inside the wall. For the TV power supply plug, use a power supply outlet that can be reached easily. Ensure good air flow so that the equipment ambient temperature does not exceed 40°C. Failure to do this may cause heat to build up inside the LCD TV, resulting in malfunction. The weight of the wall hanging bracket is approximately 3 kg (6. When fitted to the LCD TV, the total weight is approximately 23 kg (50. Check the wall strength at the 6 attachment locations by referring to the dimension drawing of the wall hanging bracket (given at right), and provide adequate reinforcement if strength is not sufficient. There are 12 holes in the wall hanging bracket. If the wall material is wood, and adequate attachment strength cannot be ensured by fastening at the 6 points at right, use as many spare holes as necessary. However, exercise care because some wall materials may crack if screws are located too close together. Do not fit at any location where these dimensions cannot be secured. Unit: mm (inches) Be sure to fit screws and tighten securely. Provide spacing for the LCD TV of at least 100 mm (3 15/16 inches) to the top and right side, at least 300 mm (11 13/16 inches) to the left side, at least 100 mm (3 15/16 inches) to the bottom and at least 42 mm (1 21/32 inches) to the rear. Fit wall hanging bracket to wall ⷠFit so that the arrow marks on the wall hanging bracket point upward. [. . . ] (3) After the above preparation , wire to equipment. (4) Refit the terminal cover removed during "Prepare the LCD TV. (1) After wiring, remove the red screw for open/close fastening on the left side from the lock bracket fastening hole , lift the LCD TV slightly towards yourself, and then slowly let it swing down again. (2) Securely fasten the red screws for open/close fastening (1 each on the left and right) to the fitting holes on the side of the unit. [. . . ]