User manual PANASONIC TYWK42DR1

[. . . ] This may cause heat to build up inside the plasma display, resulting in a fire. Do not fit at any locations subject to humidity, dust, smoke, steam or heat. When using the wall-hanging bracket, do not block the space between the rear surface of the plasma display and the wall surface. Otherwise heat may build up inside and cause a fire. [. . . ] If using a chemically-treated cloth, follow the instructions supplied with the cloth. ) 3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the wall-hanging bracket. Do not allow long-term contact with rubber, vinyl products or the like. Do not subject it to a strong force or impact. This bracket is intended for only Panasonic plasma display models (See page 83-84). Base upper and lower fitting (2) Bracket base left fitting (1) Bracket base right fitting (1) Screw for assembling the fixture (8) M5×10 Screw for securing unit (long) (1) Screw for securing unit (short) (1) [The images shown in this manual are for illustrative purpose only. The wall-hanging bracket is for use in attaching a plasma display unit to a vertical wall for viewing. Do not fit to any surface other than a vertical wall. To ensure correct plasma display performance and prevent trouble, do not fit at any of the following locations. Where there is a risk of exposure to vibration or impact · Near high-voltage wires or dynamic power supplies · Near sources of magnetism, heat, water vapor or soot · locations exposed to air blown from heating equipment · Where droplets of condensation from an air conditioner or other unit may form Fit using techniques suited to the structure and materials of the fitting location. Use screws or nuts with a nominal diameter of 6 mm (0. For the wall mounting screws, use commercially available screws with a nominal diameter of 6 mm (0. 2 inches) that are suited to the material/structure to which you are fitting the bracket. Use screws that are sufficiently strong. If you are embedding the screws, make sure they protrude from the wall surface by 10 to 15 mm (0. Screw for securing unit (short) Screw for securing unit (long) Loosely tightening the screw for securing the unit Insert the screw for securing the unit into the base left or right fitting and loosely tighten it (turn it two or three times). Horizontal installation : Screw holes at bottom of side of base left and right fittings Vertical installation : Screw holes at top and bottom of left side of fitting (Select and use the hole that will make it easier for you to install the plasma display. Attaching the insulation spacers Place the front surface of the plasma display on a clean cloth that has no dirt or foreign objects on it, and follow the procedure below. If the plasma display has any protruding parts, take care not to scratch or damage them. Remove the four caps from the plasma display using a Phillips head screwdriver. note · Keep the caps that were removed in a safe place. [. . . ] Tightening up the screw for securing unit too much may cause the bracket to be bent out of shape. Screw for securing unit (long) (Tightening torque: 2. Place a soft blanket or piece of cloth underneath the plasma display. Remove the screw for securing unit which is attached to the side of the wall-hanging bracket. [. . . ]