User manual PANASONIC TYWK42PR20

[. . . ] Do not use any plasma displays other than those given in the catalogue. Otherwise the unit may be dropped and become damaged, and personal injury may result. Do not install the plasma display in any other way than the steps specified in these instructions. Otherwise the unit may be dropped and become damaged, and personal injury may result. [. . . ] Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. For the plasma display power supply plug, use a power supply outlet that can be reached easily. Take sufficient care and ensure safety around you when performing the installation work. Otherwise, the cabinet may be bent or damaged by high heat. Assemble it according to the size of the plasma display. Place the base upper and lower fittings and base left and right fittings as shown in the diagram. Insert the projecting parts (tabs) of the base left and right fittings into the cutouts of the base upper and lower fittings (two positions on right, and two on left), and secure the fittings with the screws for assembling the fixtures (4). Please hold the bracket base left and right fittings as you work with the assembled wall hanging bracket. Holding the base upper and lower fittings might deform this unit. Base upper and lower fitting (side with the model nameplate attached) Outside (A): 58V model Inside (B): 42/50V model Refer to the instruction manual of the plasma display, and check the weight of the plasma display unit which will be fitted into the wall-hanging bracket. refer to the outline drawing of the wall-hanging bracket shown on the right , and check the wall strength at the six installation positions shown. If the strength at any of these positions is lacking, provide sufficient reinforcement. notes · There are five pre-drilled mounting holes at the top and another five at the bottom of the wall-hanging bracket. Use the spare holes provided if wood or some other material is used for the wall and a sufficient level of mounting strength cannot be ensured by anchoring the fixture at the six positions shown on the right. However, bear in mind that, depending on which materials the mounting surface is made of, cracks may form on the surface if the screws are used at positions which are too close together. Do not mount or place any other product other than the plasma display on the fixture. Wall mounting holes (at 6 points) Use the screws without fail to anchor the fixture. If it is necessary to embed screws or nuts in the wall prior to installing the wall-hanging bracket because the wall is made of concrete or such other materials, determine the positions of the holes by fitting the actual wall-hanging bracket or calculating from the figures shown in the outline drawing, and then embed screws or nuts with a nominal diameter of 6 mm (0. If you are embedding the screws, make sure they protrude from the wall surface by 10 to 15 mm (0. For the wall mounting screws, use commercially available screws with a nominal diameter of 6 mm (0. 2 inches) that are suited to the material/structure to which you are fitting the bracket. [. . . ] Detta kan leda till överhettning inuti plasmaskärmen och skapa risk för brand. Säkra minst 10 cm utrymme ovanför, under, till vänster, och till höger om plasmaskärmen. Sätt i de utskjutande delarna (flikarna) av basens vänster och höger kopplingar i utskärningarna i basens övre och undre kopplingar (två positioner till höger, och två till vänster), och säkra kopplingarna med skruvarna för montering av fixturerna (4). Om du bygger in skruvarna, se till så att de sticker ut från väggytan med 10 till 15 mm. [. . . ]