User manual PANASONIC TY-WK42PR4W

[. . . ] Do not use any television and displays other than those given in the catalogue. Otherwise the unit may be dropped and become damaged, and personal injury may result. Do not fit at any locations subject to humidity, dust, smoke, steam or heat. The work of fitting or removing the plasma TV must be performed by at least two people. [. . . ] If the unit is installed or removed improperly, the display may fall down and personal injury may result. The wall-hanging bracket is for use in attaching a plasma TV unit to a vertical wall for viewing. Do not fit to any surface other than a vertical wall. To ensure correct plasma TV performance and prevent trouble, do not fit at any of the following locations. Where there is a risk of exposure to vibration or impact · Near high-voltage wires or dynamic power supplies · Near sources of magnetism, heat, water vapor or soot · locations exposed to air blown from heating equipment · Where droplets of condensation from an air conditioner or other unit may form. fit using techniques suited to the structure and materials of the fitting location. Use commercially available screws with a nominal diameter of 6 mm that are suited to the wall material (wood, steel frame, concrete etc. For the TV power supply plug, use a power supply outlet that can be reached easily. Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C. Failure to do this may cause heat to build up inside the plasma TV, resulting in malfunction. Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. Take sufficient care to ensure safety around you when performing the assembly and installation work or while moving about during the course of the work. Otherwise, the cabinet may be bent or damaged by high heat. [The images shown in this manual are for illustrative purpose only. [Never use any other method than specified to install. (2) Check the wall strength at the 6 attachment locations by referring to the dimension drawing of the wall-hanging bracket (given at right), and provide adequate reinforcement if strength is not sufficient. If the wall material is wood, and adequate attachment strength cannot be ensured by fastening at the 6 points at right, use as many spare holes as necessary. However, exercise care because some wall materials may crack if screws are located too close together. Do not attach or place anything other than the plasma TV on the bracket. * Be sure to fit screws and tighten securely. (2) Fasten the screw at the top center hole (A) first. [. . . ] The bolt should be securely tightened to the torque given below. Be sure to fit the fastening screws on the left keep lifting upward. And right to keep the plasma TV from falling off the wall-hanging bracket. Red screw for open/ close fastening Hole for red screw for open / close fastening Fastening screw fitting position Plasma TV fastening screw (1) Remove the screws for unit fastening (1 each on the left and right) that are fitted to the wallhanging bracket sides. [. . . ]