User manual PANASONIC TY-WK4P1RW

[. . . ] Do not use any television and displays other than those given in the catalogue. Otherwise the unit may be dropped and become damaged, and personal injury may result. Do not fit at any locations subject to humidity, dust, smoke, steam or heat. The work of fitting or removing the plasma TV must be performed by at least two people. [. . . ] Where there is a risk of exposure to vibration or impact · Near high-voltage wires or dynamic power supplies · Near sources of magnetism, heat, water vapor or soot · locations exposed to air blown from heating equipment · Where droplets of condensation from an air conditioner or other unit may form. fit using techniques suited to the structure and materials of the fitting location. Use commercially available screws with a nominal diameter of 6 mm (0. 2 inches) that are suited to the wall material (wood, steel frame, concrete etc. For the TV power supply plug, use a power supply outlet that can be reached easily. Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma TV, resulting in malfunction. Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. Take sufficient care to ensure safety around you when performing the assembly and installation work or while moving about during the course of the work. Otherwise, the cabinet may be bent or damaged by high heat. [The images shown in this manual are for illustrative purpose only. Lay the base upper and lower fittings and the bracket base left and right fittings and as shown in the figure. Fit the protrusions (tabs) of the bracket base left and right fittings into the cutouts (2 on the left and 2 on the right) in the base upper and lower fittings, and secure the parts using the four screws for assembling the fixture. [Never use any other method than specified to install. ] Base upper and lower fittings Bracket base left fitting Bracket base right fitting Refer to the instruction manual of the plasma TV, and check the weight of the plasma TV unit which will be fitted into the wall-hanging bracket. refer to the outline drawing of the wall-hanging bracket shown on the right , and check the wall strength at the six installation positions shown. If the strength at any of these positions is lacking, provide sufficient reinforcement. notes · There are five pre-drilled mounting holes at the top and another five at the bottom of the wall-hanging bracket. Use the spare holes provided if wood or some other material is used for the wall and a sufficient level of mounting strength cannot be ensured by anchoring the fixture at the six positions shown on the right. However, bear in mind that, depending on which materials the mounting surface is made of, cracks may form on the surface if the screws are used at positions which are too close together. Mount or place only a plasma TV on the fixture: Do not mount or place any other product. [. . . ] Securely tighten the left and right red-marked screws (one at the left and one at the right) used to anchor and release the plasma TV in the red-marked screw mounting holes on the side of the wall-hanging bracket used to anchor and release the plasma TV. In order to prevent the plasma TV from becoming disengaged from the wall-hanging bracket, the Unit fastening screws must be securely tightened at the left and right as far as their bases. Red-marked screw used to anchor and release the plasma TV Unit fastening screw Hole for mounting the screw used to anchor the plasma TV Mounting hole for redmarked screw used to anchor and release the plasma TV Wall-hanging bracket How to remove the plasma TV from the wall-hanging bracket remove the Unit fastening screws (one at the left and one at the right) installed at the sides of the wall-hanging bracket. While lifting the bottom part of the plasma TV, pull the plasma TV toward you. [. . . ]