User manual PANASONIC TY-WK5P1SW

[. . . ] Do not use any television and displays other than those given in the catalogue. Otherwise the unit may be dropped and become damaged, and personal injury may result. Do not fit at any locations subject to humidity, dust, smoke, steam or heat. The work of fitting or removing the plasma TV must be performed by at least two people. [. . . ] For the TV power supply plug, use a power supply outlet that can be reached easily. Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma TV, resulting in malfunction. Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. Take sufficient care to ensure safety around you when performing the assembly and installation work or while moving about during the course of the work. Otherwise, the cabinet may be bent or damaged by high heat. [The images shown in this manual are for illustrative purpose only. Lay the base upper and lower fittings and the bracket base left and right fittings and as shown in the figure. Fit the tabs of the bracket base left and right fittings into the cutouts of the base upper and lower fittings above, and secure them using the two screws used to assemble the bracket. Open slightly the bottom of the bracket base left and right fittings, and fit their tabs into the cutouts of the base upper and lower fittings, and secure them using the two screws used to assemble the bracket. Tighten the screws for securing the bracket base left and right fittings which were loosen in step 1. note · Please hold the bracket base left and right fittings as you work with the assembled wall hanging bracket. Holding the base upper and lower fittings might deform this unit. [Never use any other method than specified to install. Screw for securing the bracket base fitting Base upper and lower fittings Bracket base left fitting Inside : 46-inch model Outside : 50 or 54-inch model Refer to the instruction manual of the plasma TV, and check the weight of the plasma TV unit which will be fitted into the wall-hanging bracket. If the strength at any of these positions is lacking, provide sufficient reinforcement. notes · There are five pre-drilled mounting holes at the top and another five at the bottom of the wall-hanging bracket. Use the spare holes provided if wood or some other material is used for the wall and a sufficient level of mounting strength cannot be ensured by anchoring the fixture at the six positions shown on the right. However, bear in mind that, depending on which materials the mounting surface is made of, cracks may form on the surface if the screws are used at positions which are too close together. Mount or place only a plasma TV on the fixture: Do not mount or place any other product. For details on the dimensions applying when the plasma TV is mounted, refer to the outline drawing (See back cover). [. . . ] Tighten up the long bolt for securing the unit , which was secured loosely in step 5 of section 3, until it will go no further. note · Tightening up the long bolt for securing the unit or the screw for securing the unit too much may cause the bracket to be bent out of shape. How to remove the plasma TV from the wall-hanging bracket surface of wall 1. Place a soft blanket or piece of cloth underneath the plasma TV unit. [. . . ]