User manual PANASONIC TY-WK6P1RW

[. . . ] Small children might accidentally swallow the cap. If you think your child has swallowed the cap, consult a doctor immediately. Do not use any television and displays other than those given in the catalogue. Otherwise the unit may be dropped and become damaged, and personal injury may result. [. . . ] Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma TV, resulting in malfunction. Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. Take sufficient care to ensure safety around you when performing the assembly and installation work or while moving about during the course of the work. Otherwise, the cabinet may be bent or damaged by high heat. [The images shown in this manual are for illustrative purpose only. Lay the base upper and lower fittings and the bracket base left and right fittings and as shown in the figure. Fit the protrusions (tabs) of the bracket base left and right fittings into the cutouts (2 on the left and 2 on the right) in the base upper and lower fittings, and secure the parts using the eight screws for assembling the fixture. Please hold the bracket base left and right fittings as you work with the assembled wall hanging bracket. Holding the base upper and lower fittings might deform this unit. [Never use any other method than specified to install. Base lower fitting (side with the label attached) M5 × 10 screws for assembling the fixture Refer to the instruction manual of the plasma TV, and check the weight of the plasma TV unit which will be fitted into the wall-hanging bracket. refer to the outline drawing of the wall-hanging bracket shown on the right , and check the wall strength at the six installation positions shown. If the strength at any of these positions is lacking, provide sufficient reinforcement. notes · There are nine pre-drilled mounting holes at the top and another nine at the bottom of the wall-hanging bracket. Use the spare holes provided if wood or some other material is used for the wall and a sufficient level of mounting strength cannot be ensured by anchoring the fixture at the six positions shown on the right. However, bear in mind that, depending on which materials the mounting surface is made of, cracks may form on the surface if the screws are used at positions which are too close together. Mount or place only a plasma TV on the fixture: Do not mount or place any other product. First of all, secure the screw in the upper center hole . Use a level to ensure that the fixture is not tilting on one side, and then secure the screws in the five remaining holes. notes · If it is necessary to embed screws or nuts in the wall prior to installing the wallhanging bracket because the wall is made of concrete or such other materials, determine the positions of the holes by fitting the actual wall-hanging bracket or calculating from the figures shown in the outline drawing, and then embed screws or nuts with a nominal diameter of 6 mm (0. [. . . ] While lifting the bottom part of the plasma TV, pull the plasma TV toward you. Once the insulation spacers at the bottom have been released, lift the plasma TV straight up. note · Only a professional should remove the plasma TV from the wallhanging bracket. Detta kan leda till överhettning inuti plasma-TV:n och skapa risk för brand. [. . . ]