User manual PANASONIC U100PE1E8

[. . . ] Once in the unit, such animals can cause malfunctions, smoke or fire when making contact with electrical parts. Do not insert fingers, rods or other objects into the air inlet or outlet. When the fan is rotating at high speed, it will cause injury. Never let the indoor unit or the remote controller get wet. [. . . ] It may take some time before the fan starts. The operation lamp goes off and the system stops operation. Do not turn off power immediately after the unit stops, but wait for at least 5 minutes. The heating capacity drops when the outside temperature falls. If this happens, use another heating device together with the unit. (When using together with appliances that produce open fire, ventilate the room constantly. ) Do not place appliances that produce open fire in places exposed to the air flow from the unit or under the unit. It takes some time to heat up the room from the time the unit is started since the unit uses a hot-air circulating system to heat the entire room. If the hot air rises to the ceiling, leaving the area above the floor cold, we recommend that you use the circulator (the indoor fan for circulating air). For the following conditions, a micro computer controls the air flow direction which may be different from the display. When the room temperature is higher than the set temperature. However, it is possible to changeover to program dry with slave remote controllers if the system is in cooling operation set by the master remote controller. How to designate the master remote controller 1 Press the operation mode selector button of the current master remote controller for 4 seconds. The display showing (change-over under centralized control) of all slave remote controllers connected to the same outdoor unit or HR unit flash. 2 Press the operation mode selector button of the controller that you wish to designate as the master remote controller. This remote controller is designated as the master remote controller and the display showing (change-over under centralized control) vanishes. Never place objects near the air inlet or the air outlet of the unit. it may cause deterioration in the effect or stop the operation. Turn off the main power supply switch to the unit when the unit is not used for longer periods of time. if the switch is on , it uses electricity. Before restarting the unit, turn on the main power supply switch 6 hours before operation to ensure smooth running. (Refer to "Maintenance" in the indoor unit manual. [. . . ] 20, 000 hours 25, 000 hours 5 years 5 years 25, 000 hours 8 years 20, 000 hours 20, 000 hours Damage due to taking apart or cleaning interiors of units by anyone other than our authorised dealers may not be included in the warranty. Moving and discarding the unit Contact your dealer for removing and reinstalling the total unit. Contact your dealer when discarding this unit. It is required by law to collect, transport and discard the refrigerant in accordance with the "hydrofluorocarbon collection and destruction" regulations. [. . . ]