User manual PANASONIC VB44030

[. . . ] Technical Manual Supports DBS 576HD Version 5. 0 Before attempting to operate the DBS 576HD, please read these instructions completely. DBS 576 - Version 5. 0 Issued September 2001 The contents of this document are subject to change without notice and do not constitute a commitment on the part of Panasonic Telecommunication Systems Company (PTSC). Every effort has been made to ensure the accuracy of this document. However, due to ongoing product improvements and revisions, Panasonic cannot guarantee the accuracy of printed material after the date of publication nor can it accept responsibility for errors or omissions. Panasonic will update and revise this document as needed. [. . . ] To take a caller off speaker (disable Offhook Monitor) but continue the call via the handset, press the ON/OFF key. Hardware Requirements · N/A Related Programming · FF1-0-01: Offhook Monitor Considerations · · Offhook Monitor is available on 44-Series phones only. Offhook Monitor can be disabled system-wide. Offhook Signaling Description Offhook Signaling sends a tone to a busy extension to indicate that another CO call has arrived or a call is camped-on. Operation After receiving an offhook signal during a call: Action 1. Press the flashing FF key for the CO line of the incoming call. First call on hold Result Note: For details about handling multiple calls, see "Call Hold" on page 5-18. Hardware Requirements · 5-64 N/A DBS 576HD (USA) issued September 2001 576-50-700 Section 700 - Operation Chapter 7. SLT Features Related Programming · · · FF3: CO Off-Hook Signal. The CO call type may be multiple ring, direct, BLF Ring, or camp-on. The System does not send the offhook signal under the following conditions: · During a conference call · During an OHVA or Busy override · Data Privacy is enabled · the receiving telephone is a 3rd party voice mail. Considerations Offhook Voice Announce Description You can interrupt a busy extension when making an Intercom Call, and then use the Off-Hook Voice Announce (OHVA) feature to make an announcement that only the called party can hear. You can also transfer a held call to a busy extension after making the announcement using this feature. The called party may optionally reply to (answer) an OHVA call. The busy party can reply to an offhook announcement with a text message that displays on the announcing phone. Any one of the following messages can be selected. Messages 6 to 9 and 0 have no default message text. All the messages can be changed through system programming. (see "Set Text Message Replies" on page 4-37 for more information on setting Text Message Replies). Prior to the release of Version 2. 7, it was not possible for a caller to activate the OHVA feature when a call was placed to an available second or third Directory Number (DN) key. Beginning with Version 2. 7, the calling party can activate the OHVA feature even when the second and/or third DN key is available. Depending on how this feature has been programmed, the calling party hears one of three different tones. Ring-Back Tone or Special Tone is heard when a call is placed to a "non-Voice Mail assigned" extension. When a call is placed to a "Voice Mail assigned" number, Ring-Back Tone or Busy Tone may be heard. Text Message Replies Message No. 1 2 3 4 5 Message Text Take A Message Please Hold Will Call Back Transfer Unavailable Message No. 6 7 8 9 0 Message Text User Defined User Defined User Defined User Defined User Defined 576-50-700 DBS 576HD (USA) issued September 2001 5-65 Chapter 7. SLT Features Section 700 - Operation Operation To make an OHVA : Action 1. Lift the handset or press the ON/OFF key. [. . . ] Before a route is considered, the required ARS level is compared to the originator's ARS level. If the originator's ARS level is greater than or equal to the required ARS level, the trunk group listed for the route will be searched for an available trunk. If no trunk is found, the system will attempt to use the next priority route. In this example for Pattern 1, the system will first compare the Priority 1 ARS level for the call. [. . . ]