User manual PANASONIC VB44220A

[. . . ] User Guide 900 MHz VB-44240A Cordless Telephone Issued July 2001 The contents of this manual are subject to change without notice and do not constitute a commitment on the part of Panasonic Telecommunication Systems Company (PTSC). Every effort has been made to ensure the accuracy of this document. However, due to ongoing product improvements and revisions, Panasonic cannot guarantee the accuracy of printed material after the date of publication nor can it accept responsibility for errors or omissions. Panasonic will update and revise this document as needed. [. . . ] Place the cover and slide the cover up until it latches into the handset. 12 Installing the 900 MHz Cordless Telephone 5. CHARGING THE HANDSET BATTERY (FIRST TIME) The Rechargeable Nickel-Cadmium Battery must be fully charged before using your 900 MHz phone for the first time. Place the handset in the front slot of the charging unit. If the CHARGE light doesn't light, check to see that the AC Adapter is plugged in, and that the handset is making good contact with the charging unit charging contacts. Before doing so, consider the following: · Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when screws are inserted into the wall. · Ensure that the wall material is capable of supporting the weight of the base station. · Use #10 screws with anchoring devices suitable for the wall material at the mounting point. Insert two mounting screws in the wall, 3-15/16 inches apart. Allow about 3/16 of an inch between the wall and screw heads for mounting the base station. Perform steps 1 to 3 of "Standard Wall Plate Mounting" on page 15. Plug a telephone cord into the LINE IN jack on the base station. Connect the other end to the wall jack leading to the Panasonic PBX. Plug a telephone cord from a Panasonic key telephone into the LINE OUT jack on the base station. 900 MHz Cordless Telephone User Guide 17 Installing the 900 MHz Cordless Telephone 5. Place the telephone cord(s) inside the molded channel(s) on the bottom of the Wall Mount Adapter. Place the base station on the posts of the wall screws and push down until firmly seated. Plug the AC Adapter into a standard 120V AC wall outlet. WALL-MOUNTING THE CHARGING UNIT (OPTIONAL PROCEDURE) The charging unit is also designed to be wallmounted. Before mounting your charging unit, consider the following: · Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. · Make sure the wall material is capable of supporting the weight of the charging unit. · Use #10 screws with anchoring devices suitable for the wall material at the mounting point. 18 Installing the 900 MHz Cordless Telephone 1. Insert two mounting screws 1-9/10 inches apart. Allow about 3/16 of an inch between the wall and screw heads for mounting the phone. 2. Plug the AC Adapter into the charging unit. [. . . ] You will hear a beep * 900 MHz Cordless Telephone User Guide 31 Programming Your Handset confirming that you are in programming mode. By default, the F1 key will be selected. Scroll forward through the key selections by pressing the R/VOL key, or move backwards by pressing the MUTE key. Press the "0" key to confirm your F-key selection. [. . . ]