User manual PANASONIC VB611DSUK

[. . . ] The software and hardware described in this document may be used or copied only in accordance with the terms of the license pertaining to said software or hardware. Reproduction, publication, or duplication of this manual, or any part thereof, in any manner, mechanically, electronically, or photographically, is prohibited without permission of the Panasonic Telecommunication Systems Company (PTSC). © Copyright 2001 by Panasonic Telecommunication Systems Company (PTSC). All rights reserved. CONTENTS Precautions. [. . . ] The base station can also be mounted on a standard AT&T or GTE wall plate, or directly on a wall, using the Wall Mount Adapter. Avoid locations surrounded by metal surfaces. Keep the base station and handset away from excessive heat and humidity, and from sources of electrical noise (motors, transformers, fluorescent lighting, or computers). Mount the base station and your key telephone at least three to four feet apart to avoid noise from the key telephone speaker. If you are installing multiple base units, place them at least five feet apart. 900 MHz Cordless Telephone User Guide 9 Installing the 900 MHz Cordless Telephone 2. CONNECTING THE TELEPHONE CORDS The base station for your 900 MHz phone must be connected to the Panasonic PBX. You can also connect a Panasonic key phone to the base station. Caution: Never install telephone wiring during a lightning storm. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. Connecting the Base Station to the PBX and Key Telephone Key Telephone LINE OUT LINE IN PBX 10 Installing the 900 MHz Cordless Telephone 3. Route the power cord where it will not create a trip hazard, or where it could become chafed and create a fire or other electrical hazards. 3. 1 Applying Power to the Base Station Use only the supplied AC Adapter (EXP9704). 3. 2 Applying Power to the Charging Unit Use only the supplied AC Adapter (AD970). 900 MHz Cordless Telephone User Guide 11 Installing the 900 MHz Cordless Telephone 4. Remove the battery cover by pressing the latch and sliding the cover down and off of the handset. This is especially convenient for base stations that are not easily accessible. Place the charging unit on the posts of the wall screws and push down until firmly seated. Strain Relief 4. Plug the AC Adapter into a standard 120V AC wall outlet. 900 MHz Cordless Telephone User Guide 19 Installing the 900 MHz Cordless Telephone 20 Using Your 900 MHz Cordless Telephone BEFORE YOU BEGIN · Ensure that your 900 MHz phone has been installed as described in "Installing the 900 MHz Cordless Telephone" on page 9. Remove the handset from the charging unit before using the handset. Raise the base station antenna to the vertical position. Ensure that the Cordless LED "CORDLESS" LED on the base station is lit. · · · Note: When you pick up the ACQUIRING LINK handset and press TALK, you may see this message momentarily: This message disappears when the base station obtains an open line from the PBX. PLACING A CALL 1. To end the call, press TALK. 900 MHz Cordless Telephone User Guide 21 Using Your 900 MHz Cordless Telephone ANSWERING A CALL If the handset is out of the charging unit: · Press TALK or any key on the numeric keypad. If the handset is in the charging unit: 1. Remove the handset from the charging unit. (The AutoTalk feature allows you to answer the call immediately. ) 2. When you finish the call, place the handset back in the charging unit. [. . . ] Note: For detailed programming instructions, see your key telephone user manual. A largedisplay key telephone is recommended for programming. 1. To enter the 900 MHz handset programming mode from standby mode, press and hold the and # buttons. While holding those buttons, press the TALK button. [. . . ]