User manual PANASONIC VLFKD2FX

[. . . ] VL-FKD2 Polski Română Table of Contents Introduction Accessory information For your safety Important safety instructions For best performance Other important information Controls Installation/Registering the repeater to the main monitor Wall mounting Troubleshooting Cleaning Specifications General information 2 3 4 5 Magyar 5 5 7 8 9 10 10 10 11 Thank you for purchasing a Panasonic product. Please read this manual before using the product and save it for future reference. Introduction This product is an additional product designed to be used with the following Panasonic Video Intercom Systems. € VL-SWD501/VL-SWD501U (Main monitor station: VL-MWD501) (The corresponding models are subject to change without notice. [. . . ] ) CAUTION Preventing fire and electric shock R Do not use the product in areas that are exposed to rain, moisture, steam, or oily smoke, or areas that have excessive dust. Preventing accidents, injuries, and property damage R Do not use the product in unstable areas or areas prone to strong vibrations. When mounting the product to a wall, install the product securely adhering to the instructions in this manual to prevent it from falling off the wall. Avoid installing onto low-strength walls, such as gypsum board, ALC (autoclaved lightweight concrete), concrete block, or veneer (less than 18 mm thick) walls. These may cause the product to fall, resulting in damage to the product or injury. 4 Important safety instructions When using your product, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Do not use this product near water for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement or near a swimming pool. Use only the AC adaptor indicated in this manual. SAVE THESE INSTRUCTIONS For best performance Location/avoiding noise The repeater and other compatible Panasonic units use radio waves to communicate with each other. 90 GHz, and the RF transmission power is 250 mW (max. ) R Install the repeater within the main monitor range of the Video Intercom System in an indoor environment. 100 m) and noise-free communications, install your repeater: – at a convenient, high, and central location with no obstructions between the sub monitor (or camera) and repeater in an indoor environment. – away from electronic appliances such as TVs , radios , personal computers , wireless devices , or digital cordless phones. € facing away from radio frequency transmitters, such as external antennas of mobile phone stations. (Avoid installing the repeater near a window. ) R Coverage and voice quality depends on the local environmental conditions. R If the reception for a repeater location is not satisfactory, move the repeater to another location for better reception. Environment R Keep the product away from electrical noise generating devices, such as fluorescent lamps and motors. r The product should not be exposed to direct sunlight. R Do not place heavy objects on top of the product. R When you leave the product unused for a long period of time, unplug the product from the power outlet. R The product should be kept away from heat sources such as radiators, cookers, etc. [. . . ] †Install the sub monitor or camera within signal range of the repeater. R The repeater is too far from the main monitor. (The indicator is lit or flashing in red. ) →Install the repeater in a location where the ID ID indicator is stable and lit in green or orange. [. . . ]