User manual PANASONIC VLGC003A

[. . . ] All the safety and operating instructions should be read before the appliance is operated. The safety and operating instructions should be retained for future reference. All warnings on the appliance and in the operating instructions should be adhered to. All operating and use instructions should be followed. [. . . ] If smoke rises, or an unaccustomed noise or smell is discharged from the unit. If metal objects have been dropped inside the monitor station. Do not put your ear(s) near the speaker, as loud sounds emitted from the speaker may cause hearing impairment. Only a qualified technician is allowed to connect a power cable to the unit. Do not make any wiring connections when the power supply is turned on. Never install wiring during a lightning storm. When existing chime wires are used, it is possible that they contain AC voltage. Electric shock or unit damage could result. Be sure to install the unit as specified to endure the mass. If the wiring is outdoors, use a protection tube or a surge protector. If the wiring is underground, do not make any connections underground. WARNING ­ Unplug the monitor station from power outlets if it emits smoke, an abnormal smell or makes unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped and contact an authorized service center. For best performance L If a power failure occurs, the unit will not function. 4 Installation Introductions Included items 1 2 3 No. 1 2 3 Item Door station Wood screws Inch screws Quantity 1 4 4 Notes -----For the door station. (3. 8 mm x 20 mm, 1/8" x 3/4") For the door station. 6-32 UNC x 25 mm / 1") Optional item information Available optional items ­ Face panel (VL-GF001A-N, VL-GF001A-S, VL-GF001A-B) 5 Installation Introductions Location of controls Front view Rear view A Camera L When a visitor presses the Call Button, the camera will turn on and an image of the visitor will be shown on the display of the monitor station. B Microphone C Screw hole (for fastening the door station to the wall or switch box) D Speaker E Call Button L The Call Button is lit with a blue LED light while the power is on. L A visitor can press this button to call the monitor station. F Screw (to fasten the optional face panel in place) G Water drain hole L This hole allows rain water to drain. H Camera angle control lever L The camera angle can be adjusted when installing the door station (page 7). I Terminal connector 6 Installation Introductions Before installation L To avoid malfunction or communication disturbances, do not install the door station in the following locations: ­ Places where vibration or any other kind of impact occurs. [. . . ] Loosen the screw attached to the bottom of the door station. Set the hooks (1) on the face panel into the slots (2) and cover. Press and hold (3), while fasten by tightening the screw to fasten. Slots Hooks Face panel Door station Screw (Attached to the door station) 12 Help Cleaning Use a soft, dry cloth when cleaning. For excessive dirt, wipe the unit with a slightly damp cloth. Important: L Do not use anything containing alcohol, polish powder, powder soap, benzine, thinner, wax, petroleum, or boiling water. [. . . ]