User manual PANASONIC VLGW001A

[. . . ] Video Intercom System Flush mount unit Installation and Operation Guide Model No. VL-GW001A G This product is a flush mount unit for use only with the monitor station <VL-GM301A> and sub monitor station <VL-GM001A> for the video intercom system. It cannot be used with any other units. Safety Precautions (Be sure to observe the following. ) 1) Do not modify. [. . . ] 5) Do not install in places where there is lots of humidity or dust or where the unit may be affected by oil fumes or steam. If this is not observed, fire or electric shocks may result. The following must be observed at all times. Be sure to observe the following, otherwise malfunctions may result. I Avoid installing in the following locations I When carrying out installation work ·Locations that are subject to strong shocks or vibrations. ·All cables should be routed at least 30 cm (11 13/16") away from electric light cables or routed in separate tubes. ·Use metal pipes if routing through areas where strong magnetic fields are present. ·None of the connection cables should be unused. Please make sure that there is NOT any object within 20cm (8 inches) of the flush mount unit. This may cause a communication error or malfunction of monitor station and sub monitor station. Check before installing (Check the package contents after opening. ) Embedded mounting box Makeup panel Small screw : 4 pcs. 4 mm x 25 mm (3/16" x 1") Template Installation Installation 1 Make a hole in the wall. G Install so that the monitor screen will be at an appropriate level for the eyes of the person using it. Hole Floor 2 Place the embedded mounting box into the wall. G Check that the embedded mounting box is installed the right way up. (Check the UP mark. ) G Place the fixing plates inside the embedded mounting box (in four locations). Fixing plate Embedded mounting box 3 Tighten the four embedded mounting box screws to secure the box to the wall. Fixing plate [Cross-sectional view] G Check that the fixing plates move outside the embedded mounting box to securely clamp the box against the wall. Fixing plate Embedded mounting box Screw 4 Remove the front case and terminal cover from the bottom case of the monitor station and sub monitor station. (Refer to the installation guide provided with the video intercom system. ) Terminal cover Bottom case Front case Installation 5 Install the bottom case to the embedded mounting box with the four small screw (4 mm x 25 mm, 3/ " x 1"). 16 G If connecting a video cable, connect the video cable before installing the bottom case. small screws (supplied) Bottom case Embedded mounting box Terminal cover 6 7 Connect the cables and then attach the front case and terminal cover. (Refer to the installation guide provided with the video intercom system. ) Front case Securely insert the tabs of the makeup panel into the slots in the embedded mounting box. G Check that the makeup panel is installed the right way up. UP mark. ) (Check the G The number of makeup panel tabs are 10 tabs. [. . . ] : VL-GW001A Weight : 600 (1. 32 lbs. ) Outer dimensions For your future reference Date of purchase Serial number (found on the rear of the unit) Dealer's name and address Dealer's telephone number Attach your sales receipt here. Panasonic Consumer Electronics Company, Division of Panasonic Corporation of North America One Panasonic Way, Secaucus, New Jersey 07094, U. S. A. 9. 5, Carolina, Puerto Rico 00985, U. S. A. [. . . ]