User manual PANASONIC VL-SWD501EX

[. . . ] 5 Changing how images are displayed (wide/ zoom and pan/tilt settings) . 15 Setting the language, date and time . 4 Using SD cards (formatting/copying data/ playing images) . 17 Monitoring the outside with the doorphone . [. . . ] € The sound from your end will not be heard at the camera. Using a camera 1 : From the top menu, touch and then – The monitoring time is about 90 seconds (can be extended up to 3 minutes by performing operations during monitoring). R If the camera selection screen is displayed, touch the number of the camera that you want to monitor with and then the image. : ® : Select the camera you want to ( ) – The monitoring time is about 3 minutes. R Making a warning sound come out of the camera: : Touch [Play sound]. : ( – – – ) ( )® : "Warning" ® ® [Warning sound] ® monitor with. ® 2 The images from the camera are displayed. R Press to speak to the monitored party. 3 To end the operation, press Features available while monitoring – – – – Features available when a sensor is triggered Adjust wide/zoom and pan/tilt settings (® page 33) Adjust brightness settings (® page 34) Record monitored images (® page 20) Adjust wide/zoom and pan/tilt settings (® page 33) Adjust sound and display settings (® page 33) Make a warning sound come out of the camera (® page 24) Record monitored images (® page 20) Note: R Monitoring time: – : About 90 seconds (can be extended up to 3 minutes by performing operations during monitoring) – : About 3 minutes R In situations where it is difficult to see images, such as when it is dark or when there is backlight, change the camera’s [Brightness] setting and activate the [Backlight compensation] setting as required. (® page 27) Note: R Images from when camera sensors are triggered are automatically recorded to the SD card. (® page 25) R Once a sensor is triggered, the next sensor detection cannot be made until about 10 seconds after the first triggered images have finished being displayed. (® page 19) *1 The timing when recording starts before detections depends on the [Recording before detection] setting. (® page 27) *2 When a call is made after a sensor is triggered, audio from the main monitor or sub monitor will also be recorded. When calls are not answered: Recorded images are saved as unchecked images, and the notification indicator of the main monitor flashes to indicate that there are unchecked images. Note: R When there are multiple cameras, multiple incoming calls may be received at the same time. In this case, the most recent incoming call is given priority and recorded. R When there is an incoming call from another camera when talking or monitoring with a camera (® page 30, 31), you must end the call or monitoring in order to display and save the image from the incoming call. 6 Changing camera settings You can change the settings to match how the camera is used. How to change the settings (using the main monitor) 1. From the top menu of the main monitor, touch ® ® [Connected devices] ® [Camera]. Select the number (1 - 4) of the camera to be configured. R Operations may have to be repeated depending on the function. [. . . ] While pressing on the main monitor, press 3 times. Follow the on-screen instructions and touch the "+" marks (in 5 places) with your finger. 2 Error messages - main monitor When using devices for the first time or registering devices Display "Cannot register" Cause & Solution R Registration failed because it was not completed within the specified time. † Check that the devices to be registered are correctly connected and receiving power, and then try again. [. . . ]