User manual PANASONIC VV2008

[. . . ] You can then read the instructions completely and retain them for future reference. Analogue and Digital television --- what are they?Analogue transmission is the system that has been used for many years for broadcasting television programmes. With continuous improvements in technology it is now possible to transmit programmes in a digital format, allowing clearer pictures, more stations and other services to be displayed on screen. [. . . ] A list of favourites can be accessed by pressing the GUIDE button or the i button. See pages 12 and 13. MENU MENU EXIT 33 Child Lock menu (DVB mode) You may wish to lock a DVB programme channel to prevent access to it. Note: The data of the PIN number and locked channel will be erased by operating the Shipping condition. In DVB mode MENU Press the MENU button. When entering Child Lock menu for the first time, new PIN number setting screen is displayed. After the first time you will only need to enter a password once to display Child Lock screen. Select the channel you want to lock and then press the OK button to lock. Press the Yellow button to lock all channels. Press the Blue button to unlock all channels. The PIN number is required when you wish to watch a locked channel. If the unit is turned off it will be necessary to input the PIN number again to access any locked channels. Change the PIN number In Child Lock menu Move to Change PIN. IMPORTANT NOTES: SSwitch off the TV using the front panel switch before inserting or removing a module. SIf you are installing a TV software update, please follow the dedicated instructions supplied with the module. SInsert / remove a module straight to the CI slot. Insert the CI module: Some Common Interface Modules may be a two piece design consisting of a card reader together with the viewing card. When using this design of card, first insert the card reader firmly into the CI slot on the TV. Secondly, insert the viewing card into the reader. In DVB mode Press the MENU button. MENU Move to Setup menu. Access Setup menu. Move to DVB Setup Menu. Access DVB Setup Menu. Move to DVB System Setup. Access DVB System Setup. Move to Common Interface Module Access Common Interface Module Access the module If no module is inserted the message "No Module Inserted!" will be displayed. (If you have inserted a module, check that it is fully inserted. ) The features that now appear on screen are dependent on the contents of the selected Common Interface Module. Refer to the instructions supplied with the card or contact the vendor. In all cases, it is possible to navigate the pages using buttons on the remote control, but because the commands available must apply to all manufacturers of DVB equipment, some on-screen commands may not correspond exactly to the remote control buttons. For example: For the on-screen command `select' or `go', use the OK button. [. . . ] To obtain service please contact your local Panasonic dealer quoting the model number and serial number (both are located at the rear of the LCD TV). SPECIFICATIONS VV2008 Power Source 220 -- 240V A. C. , 50 Hz Average use : 115 W Standby condition : 1W (Without DVB recording) 10W (TV + DVB system set to record Timer programmes). Wide XGA (1, 366 x 768 pixels) 16:9 aspect ratio LCD panel 66 cmV 2x8W M3 (3, 5 mm) Jack x 1 PAL I PAL 525/60 DVB M. NTSC NTSC (AV input only) UHF E21--68. Playback of NTSC tape from some PAL Video recorders (VCR). Digital terrestrial services via UHF aerial input input. [. . . ]