User manual PANASONIC WHADC1216G6E5UK

[. . . ] Operating Instructions Air-to-Water Hydromodule + Tank Model No. Indoor Unit WH-ADC1216G6E5UK Outdoor Unit WH-UX09FE5 WH-UX12FE5 WH-UD12FE5 WH-UD16FE5 Operating Instructions Air-to-Water Hydromodule + Tank Installation Instructions attached. Serial number and production year please refer to name plate. Manufactured by: Panasonic Appliances Air-Conditioning Malaysia Sdn. Lot 2, Persiaran Tengku Ampuan, Section 21, Shah Alam Industrial Site, 40300 Shah Alam, Selangor Darul Ehsan, Malaysia. [. . . ] • The STATUS mode cannot be activated when the display shows SETTING. • The total power consumption is an estimated value based on AC 230 V and may differ from value measured by precise equipment. ■ Note: ■ Note: 8 In normal operation, the , and buttons are not in use. Dealer User Dealer Operation/settings to be done only by the authorised dealer/specialist. Operation/settings to be done by the authorised dealer/specialist or user. Display Temperature setting System temperature setting The system controls the temperature for each menu based on the outdoor ambient temperature. • To set or change the temperatures, make sure to contact your nearest authorised dealer. 1 Press and hold for 5 seconds to enter the temperature range setting mode. (The display shows SETTING. ) 2 Press 3 Press 4 Press 5 Press or or to select a menu. to confirm the setting. • Repeat steps 2 to 5 to set other menus. User Checking the temperature range 1 Press and hold 2 Press • Press or to exit. for 5 seconds to enter the temperature range setting mode. to select a menu. Menu Setting of low outdoor ambient temperature. Setting of high outdoor ambient temperature. Display -5 °C 15 °C -15 °C ~ 15 °C -15 °C ~ 15 °C HEAT Setting of water outlet temperature at low outdoor 55 °C ambient temperature. Setting of water outlet temperature at high outdoor 35 °C ambient temperature. During HEAT mode, the water outlet temperature is adjusted as <Water outlet is shown the diagram on the right. temperature> It is performed within the preset temperature range. Setting of outdoor ambient temperature to turn OFF heating operation during HEAT mode. Setting of outdoor ambient temperature to turn ON the backup heater. Setting of water outlet temperature during *1 COOL mode. Setting of sanitary water tank temperature. 25 °C ~ 55 °C max. water temp. <Outdoor ambient temperature> 24 °C 0 °C 10 °C 52 °C 5 °C ~ 35 °C -15 °C ~ 20 °C 5 °C ~ 20 °C 40 °C ~ 65 °C HEAT HEATER *1, *2 COOL TANK *1 The system is locked to operate without COOL mode. It can be unlocked only by authorised installers or our authorised service partners. *2 Only displayed when COOL mode is unlocked (Means when COOL mode is available). English 25 °C ~ 55 °C How to use Default setting Temperature setting 9 How to use User Shifting the water temperature This easily shifts the water outlet temperature if the setting is undesirable. 1 Press 2 Press to enter the water temperature shifting mode. [. . . ] • Outdoor unit or indoor unit has been installed at an incline. • Circuit breaker has tripped/activated. • Check that the power supply is working correctly, or that a power failure has not occurred. 13 English Cleaning instructions / Troubleshooting Troubleshooting The operation LED blinks and error code appears on the display. • Disconnect the power supply, and report the error code to an authorised dealer. [. . . ]