User manual PANASONIC WH-UX09HE8

[. . . ] To turn on/off the select Quick Menu Force DHW Weekly Timer Powerful Force Defrost Quiet Error Reset Force Heater R/C Lock Select each setting and confirm the setting according to the instructions displayed at the bottom of the screen. (The icons refer to each selection key. ) To return to the Main Screen, Press or . [. . . ] 4 How to use the Quick Menu Select to force the Heater on. Is English (The Force Heater mode starts approximately 1 minute after pressed. – Note: • Force Heater is disabled whenever operation is already on and ‘Disabled due to operation ON!5 Select this icon to delete (cancel) or change the pre-set Weekly Timer. € If you select “No”, the screen will return to the Main Screen. [Example of a Timer setup] Select the day(s) which you wish to edit using buttons. If all 6 patterns are not preset, this screen will be displayed. 1 Select pattern “1” ~ “6”. 2 Set the hour and minutes of the Timer. / • Select mode using 5 Set the temperature for both Zone 1 and 2 (if your system has the 2-Zone setting). – Note: • Timer is disabled when Force Heater is turned on or Heat-Cool SW is enabled. € If you have preset the Weekly Timer on 2 zones, you must repeat the same procedure with Zone 2. 6 How to use the Quick Menu Select to defrost the frozen pipes. (When the mode is accepted, below screen will be displayed. ) Force Defrost Select to restore the previous settings when error has occurred. € Make sure all units are turned off before selecting this mode which restores the whole system to the previous settings. [. . . ] € Se till så att alla enheter är avstängda innan du väljer detta läge som återställer hela systemet till de föregående inställningarna. € Velg dette for å stille inn tidsur for stille modus. 5 Still inn temperaturen for både Sone 1 og 2 (hvis systemet har innstilling for 2 soner). [. . . ]