User manual PANASONIC WJ-FS309

[. . . ] Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1965 The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The serial number of this product may be found on the bottom of the unit. [. . . ] Move the cursor to the TIME column you want to edit for the step number by pressing the C, D, A or B button. Select the desired dwell by pressing the - or + button. Steps for which a different dwell time has been selected are marked "­" in the DWELL TIME parameter. Previous settings made in the DWELL TIME parameter become invalid. Press the [FUNCTION] button to display the next page of the table. The table shown in the figure appears on the monitor screen. SEQ1(SPOT-SEQUENCE)SETUP 2 OF 2 Auto Skip 1. Move the cursor to the AUTO SKIP parameter. Note: The auto skip function is not available when playing back videotape images. Move the cursor to the CAM column you want to edit for the step number by pressing the C, D, A or B button. Select the desired camera or playback channel in the CAM column by pressing the - or + button. 1 - 16: Camera Channel P1 - P16: Playback Channel ­: Not Assigned Notes: · Pressing the Camera Number button assigns the camera channel directly. Repeat steps 1 and 2 above to assign other area numbers. Note: The multiscreen pattern of each step is determined automatically as follows: · For example, if several camera channels are assigned to area numbers, the screen segmentation that will accommodate the highest area number will be selected. · Areas not assigned a camera channel, or assigned a channel to which no camera is connected, are displayed in blackout. · Pressing the Camera Number button assigns the camera channel directly. Auto Skip 1. Move the cursor to the AUTO SKIP parameter by pressing the C or D button. Select either ON or OFF by pressing the A or B button. Note: The auto skip function is not available when playing back videotape images. 39 Preset Position 1. Move the cursor to the PRE column you want to edit for the area number by pressing the C, D, A or B button. Select the desired preset position number for the camera in the PRE column by pressing the - or + button. Repeat steps 1 and 2 above to assign other area numbers. Notes: · When the STEP parameter in this table is on PLAY, it is not possible to select a preset position in the PRE column. [. . . ] For Main Site · To display the camera images in the Local Site, operate the video multiplexer as displaying the playback image. However same functions are enabled displaying the playback image. 77 APPENDIX This Appendix details the elements for communication between the Video Multiplexer and the personal computer. For BAUD RATE, DATA BIT, STOP BIT and PARITY settings, see page 42 COM PORT SETUP menu. q Communication Protocol 1. Transmission Command The PC sends messages to operate the Multiplexer in the format shown below. [. . . ]