User manual PANASONIC WJ-MPS850

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1966 Power disconnection. [. . . ] 101) (Communication Port): Communication Port window (p. 102) (Panasonic): Opens the version information window of WJ-MPS850 Administrator Console. Clicking on "OK" button will close the window. Note: To reflect each configuration to the system, save the file by pressing the SAVE button before closing the window. After that, be sure to put the file from the PC to the unit. Master-Slave This window configures the composition of master-slave connection. Recorders selected in the Recorder window (p. 97) are activated/deactivated in the Master-Slave window. How to Display To display this window, click on the button in the main window (p. (Master-Slave) How to Display Master The Master unit and the connected recorder are displayed. 81 Slave Slave units and connected recorders are displayed. To activate/deactivate Slave units, click the ON/OFF button of a desired Slave unit. When Slave units are set to ON, their unit names become selectable in SETUP MENU to configure the parameters. (Save Exit) button Saves the configuration and closes the Master-Slave window. Put the file from the PC to the unit when the time with no necessary to the continuous system operation, such as after-hours. After the file putting, the system will automatically restart. Then, the system controllers will temporarily log out. 101 Select Setup Data File. ) The configuration file cannot be put to the unit while opening SETUP MENU. It takes a few seconds to put a file to SX150A, and you might assume the PC has been freezing. Wait until the message "Completed!" appears on the screen. If the message "Connection error" appears, the PC is incorrectly connected to the unit. Confirm the settings of WJ-MPS850 Administrator Console and retry the file putting. 102 Communication Port. ) Parameters The file name of the configuration data appears. (OK) button To get the configuration data from the unit to the PC, click on this button. (Cancel Exit) button To cancel the getting of the configuration data from the unit to the PC, click on this button. [. . . ] The receiver buffer has reached overflow capacity. Invalid operation mode caused the command error. The parameter's number, digit and range are valid, but the operation mode is invalid. ER303 Gateway reception overflow Reception buffer overflow has occurred on the other device during the gateway communication. [. . . ]