User manual PANASONIC WJ-MPU855

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1966 Power disconnection. [. . . ] Available digits: 5 or less Available numerics: 0 to 9 Notes: · Begin the entry with a numeric other than "0". Available digits: 5 or less Available numerics: 0 to 9 Note: Begin the entry with a numeric other than "0". 1 to 5: Level View & Operate: An operator can display the selected camera image on the selected monitor. The operator can also control the camera. View: An operator can display the selected camera image on the selected monitor, but cannot control the camera. --: The operator can neither display the selected camera image on the selected monitor nor control the camera. 1, 3, 5, 10, 30, or 60 min: If no operations are performed during this period in the login status, the operator logs out of the system automatically. Available parameters: 1 to 4096 OFF: Alarm occurrence is not notified. 0 sec: Every time alarm occurrence is detected, system controllers are notified. 1 sec, 3 sec, 5 sec: 1 second, 3 second, or 5 seconds after the alarm occurrence, system controllers are notified. 100 ms, 200 ms, 400 ms, 1 sec: Period until alarm notification is retried 0 to 16: Total recorder number Note: When camera input channels to supply video input signals from recorders are set to "RS485" in "System" ­ "RS485 Camera", the RS-485 settings are automatically canceled. SETUP MENU will be displayed on the selected monitor. G WV-CU360C/CJ 1. Press the SETUP button while holding down the SHIFT button. Moves the cursor: Move the joystick. The cursor is highlighted when you point. Moves to the next/previous page (When the displayed menu has two or more pages): Move the cursor to the top or bottom. The next or previous page will be displayed on the monitor. Note: When using WV-CU950/650, you can perform this operation by rotating the shuttle ring or moving the zoom wheel controller. Changes the selected parameter: Rotate the JogDial, or press the + or ­ button. Enters the numeric parameters: Press the numeric buttons. To clear the numeric entry, press the CLEAR button. Moves to the lower menu: Move the cursor to a setting item which has an arrow mark, and then press the CAM (SET) button. Moves to the upper menu: Press the MON (ESC) button. [. . . ] Delete alarm event settings with which the group sequence is associated. 66 "!" mark (in a circle) is displayed in the list of "Schedule" ­ "Timer Event". Check if the camera number or camera position number not registered is set for the event. · Register the camera number in "System" ­ "Logical Camera Number". · Register the camera position number in "Camera" ­ "Camera Position". ­ "!" mark (in a triangle) is displayed in the list of "Schedule" ­ "Timer Event". · Start time of event is set for the period during which an event with higher priority has been set. Change the settings of start time and priority of the event. ­ Monitor Display Mode parameter in "Monitor Display Mode" of "Alarm" ­ "Alarm Event" is displayed in gray, and you cannot change the parameter. · Check if the monitor is associated with an alarm event. [. . . ]