User manual PANASONIC WJ-NT304

[. . . ] Network Interface Unit Operating Instructions Model No. WJ-NT304 OPERATE LINK RC V SND Network Interfac e Unit W J-NT30 4 Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use. We declare under our sole responsibility that the product to which this declaration relates is in conformity with the standards or other normative documents following the provisions of Directives EEC/73/23 and EEC/89/336. Wir erklären in alleiniger Verantwortung, daß das Produkt, auf das sich diese Erklärung bezieht, mit der folgenden Normen oder normativen Dokumenten übereinstimmt. Gemäß den Bestimmungen der Richtlinie 73/23/EEC und 89/336/EEC. Nous déclarons sous note seule responsabilité que le produit auquel se réfère la présente déclaration est conforme aux normes ou autres documents normatifs conformément aux dispositions des directives CEE/73/23 et CEE/89/336. [. . . ] The built-in battery life is approximately 5 years as an indication of replacement. (This is just an indication of replacement. We are not providing any guarantee of the built-in battery lifetime. Replacement cost of the built-in battery is not covered by the warranty even if it needs to be done within the warranty period. ) Ask the shop where you purchased the unit when replacement of the battery is required. Do not expose this product to direct sunlight for hours and do not install the product near a heater or an air conditioner. Otherwise, it may cause deformation, discoloration and malfunction. To continue using with stable performance · Parts of this product may deteriorate and it may shorten the lifetime of this product when using in locations subject to high temperatures and high humidity. Do not expose the product to direct heat such as from a heater. · Use this product at temperature within 5 °C to 35 °C {41 °F to 95 °F} and humidity below 90%. (When using this product without turning the power off) The input power source for this apparatus is 120 V AC, 50 Hz/60 Hz. Use only the supplied power cord or AC adapter. Use the power cord that is suited to your locality. Do not strike or shake, as this may damage the product. Failure to observe this may cause trouble. About the PC monitor When displaying the same image on the PC monitor for a long time, the PC monitor may be damaged. It is recommended to use a screen-saver. When an error is detected, the unit will restart automatically. This unit will restart when detecting an error caused by any reason. The unit will be inoperable for around 2 seconds after the restart just as when the power is turned on. About SD memory card · Before inserting a SD memory card into the SD memory card slot, turn the power of the unit off. Otherwise, it may cause malfunction or damage data recorded on the SD memory card. Refer to page 16 for descriptions of how to insert/ remove a SD memory card. [. . . ] · The power cord, AC inlet or the power plug is damaged. If you continue to use it, a fire or an electric shock may occur. Unplug the power plug immediately, and refer servicing to qualified service personnel. Cause/solution Reference pages The power cord, AC inlet or the power plug are hot during use. The power cord gets warm or hot if bent or pulled during use. 18 Specifications I Network Interface Unit Power source: Power consumption: Ambient temperature: Ambient humidity: Video input connectors: Video output connectors: Audio input connector: Audio output connector: Serial port: Parallel port: Resolution: Image compression method: Audio compression method: Protocol: Camera control: Network: Security: OS: Browser: 12 V DC, 1. 0 A (using the supplied AC adapter) Approx. [. . . ]