User manual PANASONIC WJ-RT208

[. . . ] Digital Disk Recorder Operating Instructions Model No. WJ-RT208 ERRO R ALARM HDD TIMER OPERATE ALARM RESET STILL SEQUEN CE 1 2 3 4 5 ESC STOP PLAY REC 6 7 8 9 0 MENU PAUSE SET COPY 2 REV FWD SKIP Digital Disk Re corder WJ-RT 208 Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use. WARNING: · This apparatus must be earthed. · Apparatus shall be connected to a mains socket outlet with a protective earthing connection. · The mains plug or an appliance coupler shall remain readily operable. · To prevent fire or electric shock hazard, do not expose this apparatus to rain or moisture. [. . . ] In other cases, refer to the relevant instruction manual for that camera. CH Enable Mask Area Mask Enable PTZ Protocol Rec. Reserve Channel Name All OK 1 On Set Off PANASONIC 000 CH1 Cancel Days 2. 5. 1 Panning/Tilting (1) Select the desired channel by using the direction button or numeric button. The image frame of the selected channel blinks. Select the pan/tilt control mode by pressing the [SET] button once. The camera pan/tilt control icon is displayed on the screen of the selected channel. (2) Press the direction button and turn the camera in the proper direction. Note: In the pan/tilt control mode, two external units can be connected to the cameras. When the camera select button [1] is pressed, External Unit 1 is set to ON. When the camera select button [2] is pressed, External Unit 2 is set to ON. When the camera select button [6] is pressed, External Unit 1 is set to OFF. When the camera select button [7] is pressed, External Unit 2 is set to OFF. (3) Press the [SET] button 3 times to close the pan/tilt control mode. (6) Press the [MENU] button. "WJ-RT208 SETUP MENU" appears. (7) Move the cursor to "COMMUNICATION SETUP" and press the [SET] button. Then move the cursor to "RS485 SETUP" and press the [SET] button. RS485 SETUP Baud Rate Data Bit Parity Stop Bit OK 19200 8 None 1 Cancel 2. 5. 2 Auto function (Auto Pan, etc. ) (1) Select the pan/tilt control mode by pressing the [SET] button once. The camera pan/tilt control icon is displayed on the screen of the selected channel. (2) Start the auto function by pressing the [PLAY] button. Note: Refer to the Operating Instructions of the camera for descriptions of the auto function. 29 2. 5. 3 Zoom (1) Select the zoom/focus mode by pressing the [SET] button twice. The zoom/focus icon is displayed on the screen of the selected channel. (2) Press the direction button (up or down) to control the camera's zoom. [. . . ] To use all functions, press the [OSD] button ( ) on the system controller for several times. OSD 57 Troubleshooting Prior to repairing services, verification should be carried out for the respective items specified below. Contact a dealer if a problem cannot be solved even after checking and trying the solution, or if a problem is not described below, or when having an installation problem. Problem Check item/remedy Page Confirm whether the power plug is inserted in an AC wall outlet. Is the power cord connected to the power outlet of this unit? ­ ­ Is the camera lens dislodged?Is the power supply turned ON for the camera and connected devices? [. . . ]