User manual PANASONIC WJ-SW104

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: To assure continued compliance, (example use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. SA 1966 WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. 2 IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. [. . . ] Move the cursor to position 5 by moving the Joystick Controller, then press the Function F4 button to open the Pop Up Window. Move the cursor with the Joystick Controller to the desired Auto Reset time (30, 60, 90, 120, 150, 180, Off) in the Pop Up Window, and then press the CAM (SET) key to execute the selection. To select an Auto Reset time other than those displayed in the Pop Up Window in 1-second increments or decrements between 1 to 60 seconds, leave the cursor on 30 or 60 and press the INC +1CAM or DEC ­1CAM button. . . . . 57 58 59 60 90 120 150 180 Off . . . . 27 28 29 30 31 32 33. . . . Move the cursor to position 6 by moving the Joystick Controller. Press the Function F4 button to open the Pop Up Window. Select the desired spot or sequence mode to be assigned to the monitor by moving the Joystick Controller, and then press the CAM (SET) key to execute the selection. Move the cursor to position 7 by moving the Joystick Controller. Enter the desired alarm number (1-128) by pressing the Numeric keys. Move the cursor to position 8 by moving the Joystick Controller. Press the Function F4 button to open the Pop Up Window. Notes: · If plural Spot Cameras are assigned to a monitor in the event of alarm, it is recommended to program a Tour Sequence in advance. · To keep the latest alarmed Spot picture on a monitor, do the following: 1. Set both the Dwell time and Auto Reset time to 30 seconds. When several alarms are activated within a short period of time, the previous Spot picture may momentarily appear on the monitor. Make the Auto Reset time shorter than the Dwell time. If the Auto Reset time expires before the next alarm is activated, the alarm mode will be reset and the Sequence or Spot picture displayed in response to the previous alarm remains on the monitor. q Example 2: Tour Sequence (T) An alarm will activate a previously programmed Tour Sequence on the designated monitor. Contents of Example 2 setup: When Alarm 3 is activated, Tour Sequence 1 runs on Monitor 2. 4 q Example 3: Group Sequence (G) An alarm will activate a previously programmed Group Sequence on the designated monitor. Contents of Example 3 setup: When Alarm 4 is activated, Group Sequence 1 runs on Monitors 3 and 4. Important: Group Sequences must be assigned to monitors before programming the Setup menu. q Example 4: Combination of all of the above An alarm will activate a combination of the above previously programmed functions. Contents of Example 4 setup: When Alarm 5 is activated, Monitor 5 display the picture of Camera 3 at preset position 2. At the same time, Tour Sequence 2 runs on Monitor 2 and Group Sequence 2 runs on Monitors 7 and 8. q Error (E) display An attempt to assign an incompatible mode to a monitor will cause "E" for Error to be displayed in the table. [. . . ] Another operator with equal priority has taken control over that camera. Wait until event or operator releases control over all monitors. Symptom: "NOT AVAILABLE" appears on the LCD display. A Priority Lock is in effect for that monitor. [. . . ]