User manual PANASONIC WJ-SX550B

[. . . ] The fact that the equipment operates satisfactorily does not imply that the power point is earthed and that the installation is completely safe. For your safety, if in any doubt about the effective earthing of the power point, consult a qualified electrician. CAUTION: Before attempting to connect or operate this product, please read the label on the bottom. For U. K. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. [. . . ] Clock Display Position This item lets you select the position where the clock will be displayed on the Spot Monitor screen. Move the cursor to CLOCK POSITION, then press the SET button. The position setting menu appears on the monitor screen as show below. CAMTITLE 1. JAN97 0:00 Move the cursor to SYSTEM SETUP on the SETUP MENU, then press the SET button. The SYSTEM SETUP menu appears on the monitor screen as shown below. Press the FUNCTION button to display the next page. Press this button again to return to the previous page. SYSTEM SETUP CLOCK SETUP CLOCK POSITION TITLE SETUP * TITLE POSITION SEQUENCE SETUP SEQ TIMING-MLT SEQ TIMING-SPT LOCK MODE 1. JAN97 * 1 OF 2 0:00 * SEQ1 * INT(TIME-ADJ) INT ALL 2. Move the clock position by pressing the Direction Arrow Buttons. Note: The camera title and the clock are displayed on the same line of the Spot monitor. If the clock position is moved to upward or downward, the camera title is moved to that position at the same time. Press the SETUP/ESC button to execute the selection and return to the previous SYSTEM SETUP menu. 3. Camera Title Setup SYSTEM SETUP 2 OF 2 CABLE COMP/VD2/DATA SETUP * ALM TERMINAL SETUP * DATA MODE CU550A RS-232C MODE VTR COM PORT SETUP * VTR IN SELECT VIDEO DAISY MODE OFF UNIT ADDR. SET 1 This item lets you edit the camera title to be displayed on the monitor screen. The duration of each step is determined by the Dwell Time setting. Initially, it is selected at the factory that 16 camera pictures are displayed in succession. Move the cursor to the SEQUENCE SETUP parameter on the SYSTEM SETUP menu. Select SEQ1 by pressing the LEFT or RIGHT button, then press the SET button. The setup menu shown below appears on the monitor screen. SEQ1(SPOT-SEQUENCE)SETUP 1 OF 2 AUTO SKIP OFF DWELL TIME 2SEC STEP 1 2 3 4 5 6 7 8 CAM PRE TIME 1CH - 2SEC 2CH - 2SEC 3CH - 2SEC 4CH - 2SEC 5CH - 2SEC 6CH - 2SEC 7CH - 2SEC 8CH - 2SEC STEP CAM PRE TIME 9 9CH - 2SEC 10 10CH - 2SEC 11 11CH - 2SEC 12 12CH - 2SEC 13 13CH - 2SEC 14 14CH - 2SEC 15 15CH - 2SEC 16 16CH - 2SEC Auto Skip 4. Camera Title Display Position This item lets you select the camera title position to be displayed on the Spot Monitor screen. Refer to the Clock Position Setting on page 30 for more details. Move the cursor to TITLE POSITION, then press the SET button. The position setting menu appears on the monitor screen. Move the title by pressing the Direction Arrow Buttons. Note: The camera title and the clock are displayed on the same line of the Spot monitor. [. . . ] · It is recommended to set the LOCK switch to the ON position while making these connections. · For controlling more than 4 cameras, additional WV-PB6164 Data Multiplex Board should be installed in the Video Multiplexer. s Operating Procedures 1. Confirm that the camera and peripherals are connected correctly and firmly. Turn on the power switches of all system components. [. . . ]